Rebuilding cheap OEM wheels with Light Bicycle rims
#27
Senior Member
I’m 195-200, riding on 24 spoke front and rear - both the old Vision Team 30 and current Light Bicycle wheels. When I was up closer to 230 I rode for years on Magic Ksyrium Equipes with 20 spikes in front. Best idea? No clue, but those Ksyriums are still on that bike.
#28
member
Nobody mentioned Novatec hubs yet? They are very light, cheap and relatively reliable. I built countless wheelsets (road/gravel/mtb) on them and so far they been a lot more reliable than Shimano hubs (knock on the wood...)
#29
Senior Member
Thread Starter
AR46 is too narrow a front rim by modern standards. With an outer width of only 28mm, you're stuck with using a 25mm tire for optimal aero and to reduce crosswind effect. The Bontrager is better in that respect. A 28mm tire is also going to be a lot more comfortable, and work better if you run tubeless as you won't need to pump them up nearly as high a pressure.
OP, you're more than 50 lbs heavier than I am. I use a WR50/AR56 front/rear combo. They're extremely comfortable for me as I run a 32mm tire on the rear. The only downside is that the WR50 has an internal width wider than the new ERTRO standard says is safe to run 28mm tires. The Bontrager is again better there, since its internal width is narrower.
Lastly if you're going ahead with the LB rims, I've seen people lace the rears with CX Sprint spokes for better stiffness. CX Rays may be too flexy for heavier and more powerful riders.
OP, you're more than 50 lbs heavier than I am. I use a WR50/AR56 front/rear combo. They're extremely comfortable for me as I run a 32mm tire on the rear. The only downside is that the WR50 has an internal width wider than the new ERTRO standard says is safe to run 28mm tires. The Bontrager is again better there, since its internal width is narrower.
Lastly if you're going ahead with the LB rims, I've seen people lace the rears with CX Sprint spokes for better stiffness. CX Rays may be too flexy for heavier and more powerful riders.
I am currently using a 30mm clincher on the front and 32mm clincher in the back. I'll either stick with that size or consider 28mm tires in the future.
#30
Senior Member
Join Date: Nov 2017
Location: Seattle
Posts: 1,957
Bikes: Specialized Roubaix, Canyon Inflite AL SLX, Ibis Ripley AF, Priority Continuum Onyx, Santana Vision, Kent Dual-Drive Tandem
Mentioned: 20 Post(s)
Tagged: 0 Thread(s)
Quoted: 878 Post(s)
Liked 726 Times
in
436 Posts
Light Bicycle recommended a WR35 for the front which is 25mm inner and 32mm outer. This is not too wide to run a 30mm or 28mm clincher?? What is the new ERTRO standard?
I am currently using a 30mm clincher on the front and 32mm clincher in the back. I'll either stick with that size or consider 28mm tires in the future.
I am currently using a 30mm clincher on the front and 32mm clincher in the back. I'll either stick with that size or consider 28mm tires in the future.
You can run 30mm for a small penalty to crosswind stability, as the wider the tire is than the rim, the more susceptible it is to stalling at higher yaw angles.
This all matters more for the front wheel. Using a 30mm in the rear or even 32mm would be expected to have neglible impact on speed, might even be faster due to less rolling resistance, and provides more comfort than narrower tires.