Go Back  Bike Forums > Bike Forums > Classic & Vintage
Reload this Page >

Would You Use a 40 year old NOS tube.

Notices
Classic & Vintage This forum is to discuss the many aspects of classic and vintage bicycles, including musclebikes, lightweights, middleweights, hi-wheelers, bone-shakers, safety bikes and much more.

Would You Use a 40 year old NOS tube.

Old 04-11-21, 10:53 AM
  #1  
Roger M
Banned.
Thread Starter
 
Join Date: May 2010
Location: Snohomish, WA.
Posts: 2,866
Mentioned: 33 Post(s)
Tagged: 0 Thread(s)
Quoted: 469 Post(s)
Liked 2,442 Times in 646 Posts
Would You Use a 40 year old NOS tube.

Here's the story.

The bike I recently bought came with a few extra tubes. It hadn't been ridden since about 79. I pumped up the original tubes yesterday to about 100psi. I rode it a few miles and hung it up in the living room overnight. 5am and the front tube let loose and popped. Woke everyone up but Thomas(teenage son).

the rubber is still pliable and not dried out. Would you run these tubes?
Roger M is offline  
Old 04-11-21, 11:03 AM
  #2  
Dylansbob 
2k miles from the midwest
 
Dylansbob's Avatar
 
Join Date: Feb 2005
Location: Washington
Posts: 1,964

Bikes: ~'75 Colin Laing, '80s Schwinn SuperSport 650b, ex-Backroads ti project...

Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
Quoted: 525 Post(s)
Liked 931 Times in 446 Posts
I too have a couple vintage tubes that I could test. In the garage, of course.




btw, can I have some bacon?
Dylansbob is offline  
Likes For Dylansbob:
Old 04-11-21, 11:06 AM
  #3  
JulesCW 
Full Member
 
Join Date: Aug 2012
Location: Upper third of the central USA
Posts: 490

Bikes: N+1

Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Quoted: 227 Post(s)
Liked 645 Times in 318 Posts
Did the tube or the tire fail causing the blowout on the bike in question? A loud explosive failure indicates a bead that has come loose or a tire sidewall that is dust that blew out under that 100 psi.

I'd use the tube you show in the photo with a good tire.

Last edited by JulesCW; 04-11-21 at 01:16 PM.
JulesCW is offline  
Likes For JulesCW:
Old 04-11-21, 11:12 AM
  #4  
nlerner
Senior Member
 
Join Date: Dec 2005
Posts: 17,143
Mentioned: 481 Post(s)
Tagged: 0 Thread(s)
Quoted: 3803 Post(s)
Liked 6,634 Times in 2,599 Posts
Sure, I’d run it, but I’d also carry a back up!
nlerner is offline  
Likes For nlerner:
Old 04-11-21, 11:16 AM
  #5  
bikingshearer 
Crawlin' up, flyin' down
 
bikingshearer's Avatar
 
Join Date: Jan 2006
Location: Democratic Peoples' Republic of Berkeley
Posts: 5,640

Bikes: 1967 Paramount; 1982-ish Ron Cooper; 1978 Eisentraut "A"; two mid-1960s Cinelli Speciale Corsas; and others in various stages of non-rideability.

Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 1019 Post(s)
Liked 2,505 Times in 1,047 Posts
Originally Posted by Roger M
Here's the story.

The bike I recently bought came with a few extra tubes. It hadn't been ridden since about 79. I pumped up the original tubes yesterday to about 100psi. I rode it a few miles and hung it up in the living room overnight. 5am and the front tube let loose and popped. Woke everyone up but Thomas(teenage son).

the rubber is still pliable and not dried out. Would you run these tubes?
Maybe on the back. Definitely not on the front.

Bad things can happen with front tire blow-outs. Don't ask me how I know. Just trust me on this one.
__________________
"I'm in shape -- round is a shape." Andy Rooney
bikingshearer is offline  
Likes For bikingshearer:
Old 04-11-21, 11:20 AM
  #6  
Roger M
Banned.
Thread Starter
 
Join Date: May 2010
Location: Snohomish, WA.
Posts: 2,866
Mentioned: 33 Post(s)
Tagged: 0 Thread(s)
Quoted: 469 Post(s)
Liked 2,442 Times in 646 Posts
Originally Posted by JulesCW
Did the tube or the tire fail causing the blowout on the bike in question? A loud explosive failure indicates a bead that has come looses or a tire sidewall that is dust that blew out under that 100 psi.

I'd use the tube you show in the photo with a good tire.
Thanks for that question(& answer),JulesCW. I didn't bother even removing the tire or looking at it(til now).

Sure enough, the tire blew...

So where's all the 27x1 1/8" Paseles...
Roger M is offline  
Likes For Roger M:
Old 04-11-21, 01:15 PM
  #7  
JulesCW 
Full Member
 
Join Date: Aug 2012
Location: Upper third of the central USA
Posts: 490

Bikes: N+1

Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Quoted: 227 Post(s)
Liked 645 Times in 318 Posts
Originally Posted by Roger M
Thanks for that question(& answer),JulesCW. I didn't bother even removing the tire or looking at it(til now).

Sure enough, the tire blew...

So where's all the 27x1 1/8" Paseles...
Ouch! I guessed that might be the issue. Tubes go flat on bikes not ridden for a long time, but they're generally ok if the bike has not been sitting outside for decades as they're protected from sun and contaminants by the tire -- although i'll check an old tube carefully, esp. around the valve.

Not too many 40 year old tires that are any good -- especially if they've not been carefully stored!

I feel lucky when a blowout happens on a bike hanging on a hook as opposed to on the road!
JulesCW is offline  
Old 04-11-21, 01:42 PM
  #8  
cudak888 
www.theheadbadge.com
 
cudak888's Avatar
 
Join Date: Sep 2005
Location: Southern Florida
Posts: 28,508

Bikes: https://www.theheadbadge.com

Mentioned: 124 Post(s)
Tagged: 0 Thread(s)
Quoted: 2420 Post(s)
Liked 4,381 Times in 2,090 Posts
Probably just fine. I have some original 1950's Dunlop tubes in service.

Tires, on the other hand...nope.

-Kurt
__________________












cudak888 is offline  
Likes For cudak888:
Old 04-11-21, 01:45 PM
  #9  
clubman 
Phyllo-buster
 
clubman's Avatar
 
Join Date: Jan 2010
Location: Nova Scotia
Posts: 8,843

Bikes: roadsters, club bikes, fixed and classic

Mentioned: 133 Post(s)
Tagged: 0 Thread(s)
Quoted: 2295 Post(s)
Liked 2,043 Times in 1,252 Posts
I use them all the time, even have a stash, but these are for Roadster and Sports tires so they're low pressure. Where else will I source EA1, EA3, 650B, 26 x 1 3/4 etc. This is some of my NIB stock, 70's and earlier.


Last edited by clubman; 04-11-21 at 01:52 PM.
clubman is offline  
Likes For clubman:
Old 04-11-21, 03:22 PM
  #10  
scottfsmith
I like bike
 
scottfsmith's Avatar
 
Join Date: Feb 2021
Location: Merry Land USA
Posts: 662

Bikes: Roubaix Comp 2020

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 267 Post(s)
Liked 283 Times in 191 Posts
I was cleaning out my garage today, I found some ~25 year old tires and tubes. The road tires were stiff and brittle, toss. Tubes and MTB tires all looked fine, save.
scottfsmith is offline  
Likes For scottfsmith:
Old 04-11-21, 09:10 PM
  #11  
top506
Death fork? Naaaah!!
 
top506's Avatar
 
Join Date: Nov 2005
Location: The other Maine, north of RT 2
Posts: 5,324

Bikes: Seriously downsizing.

Mentioned: 49 Post(s)
Tagged: 0 Thread(s)
Quoted: 558 Post(s)
Liked 626 Times in 280 Posts
My '73 Schwinn Super Sport is running on the original tubes.

Top
__________________
You know it's going to be a good day when the stem and seatpost come right out.

(looking for a picture and not seeing it? Thank the Photobucket fiasco.PM me and I'll link it up.)
top506 is offline  
Likes For top506:
Old 04-11-21, 09:51 PM
  #12  
nlerner
Senior Member
 
Join Date: Dec 2005
Posts: 17,143
Mentioned: 481 Post(s)
Tagged: 0 Thread(s)
Quoted: 3803 Post(s)
Liked 6,634 Times in 2,599 Posts
I bought a set of fairly trashed his and hers 1930s Raleigh Sports last fall, and both came with what I imagined were original tubes. Tires were completely shot, but I pumped those tubes up, hung in the basement, and they’ve been holding that air for months now.
nlerner is offline  
Likes For nlerner:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.