Need help finding a certain nut for a Bionix system
04-09-23, 08:26 PM
#1
Senior Member
Thread Starter
Need help finding a certain nut for a Bionix system
It fits into the wheel, is smooth on the inside, holds the wheel on the non-drive side. See photo: it is missing.
04-10-23, 08:51 AM
#2
Ride more, eat less
Join Date: Feb 2007
Location: Philla PA, Hoboken NJ, Brooklyn NY
Posts: 2,075
Bikes: Too many but never enough.
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 715 Post(s)
Liked 737 Times
in
453 Posts
Something similar to an "axle spacer"?
https://www.ebay.com/itm/284397985264
https://www.amazon.com/Allstar-Perfo...df_B009Q73B2C/
https://www.ebay.com/itm/284397985264
https://www.amazon.com/Allstar-Perfo...df_B009Q73B2C/
04-10-23, 10:12 AM
#3
Senior Member
Join Date: Jul 2014
Location: socal
Posts: 4,266
Mentioned: 9 Post(s)
Tagged: 0 Thread(s)
Quoted: 883 Post(s)
Liked 824 Times
in
623 Posts
As you probably know, BionX has been out of business for several years. However, individual(s) bought the remaining stock of parts. If you check the various "e"-related sites (endless sphere, ******, MTBR), you might be able to locate them.
04-10-23, 02:01 PM
#4
Senior Member
That's the "torque reaction collar" that you're missing. BionX Legacy stocks a few sizes. You need to order one in an angle to closely match your dropout angle using the template pictured below ...
Is that a "P" series motor? If so you need the V2 collar ...
My "D" series motor uses the V3 collar ...
Is that a "P" series motor? If so you need the V2 collar ...
My "D" series motor uses the V3 collar ...
Last edited by BobG; 04-10-23 at 04:01 PM.
