Campagnolo Dropout Screw Tap
#1
Member
Thread Starter
Campagnolo Dropout Screw Tap
Need to chase new paint from dropout screw threads. Anybody know the tap size? Will post in C&V also. Thanks.
#2
Senior Member
kanawa-
Sutherlands says they are M3 x .5.
Sutherlands says they are M3 x .5.
#3
Senior Member
Join Date: Sep 2010
Location: Roswell, GA
Posts: 8,319
Bikes: '93 Trek 750, '92 Schwinn Crisscross, '93 Mongoose Alta
Mentioned: 30 Post(s)
Tagged: 0 Thread(s)
Quoted: 1438 Post(s)
Liked 1,092 Times
in
723 Posts
Get yourself some M3 x 30 or so mm socket head stainless cap screws and a couple of matching nuts, they will hold better than the original thumb nuts and springs.
#4
SE Wis
Join Date: Apr 2005
Location: Milwaukee, WI
Posts: 10,491
Bikes: '68 Raleigh Sprite, '02 Raleigh C500, '84 Raleigh Gran Prix, '91 Trek 400, 2013 Novara Randonee, 1990 Trek 970
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 2738 Post(s)
Liked 3,379 Times
in
2,044 Posts
#6
SE Wis
Join Date: Apr 2005
Location: Milwaukee, WI
Posts: 10,491
Bikes: '68 Raleigh Sprite, '02 Raleigh C500, '84 Raleigh Gran Prix, '91 Trek 400, 2013 Novara Randonee, 1990 Trek 970
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 2738 Post(s)
Liked 3,379 Times
in
2,044 Posts
I use the acorn nuts as the "knob" like on the originals with a little loctite and cranked down. I run a tap down the holes so they turn by hand.
#7
Friendship is Magic
Join Date: Nov 2010
Location: Sacramento, CA
Posts: 22,983
Bikes: old ones
Mentioned: 304 Post(s)
Tagged: 0 Thread(s)
Quoted: 26374 Post(s)
Liked 10,346 Times
in
7,189 Posts
.
...it is not at all difficult to break off a small diameter tap like this in the hole you are cleaning.
Use plenty of oil on the tap, and back it out every couple of turns to let the chips of paint and detritus clear.
They are hardened to maintain the cutting edges, so brittle. Because they are hardened, they are difficult to drill out if you break one in the dropout.
...it is not at all difficult to break off a small diameter tap like this in the hole you are cleaning.
Use plenty of oil on the tap, and back it out every couple of turns to let the chips of paint and detritus clear.
They are hardened to maintain the cutting edges, so brittle. Because they are hardened, they are difficult to drill out if you break one in the dropout.