Help with 1x12 conversion needed
#1
Junior Member
Thread Starter
Join Date: Apr 2010
Location: Denver
Posts: 13
Bikes: 2007 allez elite triple
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Help with 1x12 conversion needed
I have a 2012 anthem 29er that I'm trying to convert from 2x10 to 1x12. Got a set of sram gx shifter, cassette, and derailleur, and a 32t ring from Amazon. I installed all, and each shift causes the chain to ride on the top of the teeth on the front ring for a second, and once I get to the third largest cog or so, it jumps the front ring. Thoughts?
#2
Senior Member
Did you install a new 12 speed chain? Didn't mention that. Also getting the correct chain length and B tension are both pretty important.
Is your chainring spaced correctly for your bike's chainline?
Is your chainring spaced correctly for your bike's chainline?
#3
Senior Member
Join Date: May 2001
Location: Sunny so. cal.
Posts: 904
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 136 Post(s)
Liked 57 Times
in
31 Posts
cpach's second point is what was going thru my mind--maybe the OP got ahold of a boost chainring (I'm pretty sure 2012 is non-boost) or is using or missing a spacer?