How to program LED light combo Zecto Drive
#1
Full Member
Thread Starter
Join Date: Jul 2018
Location: Raleigh, NC
Posts: 229
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 176 Post(s)
Liked 57 Times
in
36 Posts
How to program LED light combo Zecto Drive
Bought one of these this week but can't figure out how to program it. It has a buttom on the top (can be seen in the photo below at the top of the device). The light comes on when I hold down the button, but when I release, the light turns off. Instructions say hold the bottom 5 seconds, 2 seconds, etc., but that doesn't work to program anything. Light comes on only when button is held down. Any ideas?