Nitto stem clamp diameter?
#1
Junior Member
Thread Starter
Nitto stem clamp diameter?
Can anyone tell just by looking if this Nitto stem is for 26.0 or 25.4 bars? Not sure if "T.W." is a clue or not.
Thanks!
Thanks!
#2
Senior Member
Join Date: Jan 2008
Location: Beaverton, OR
Posts: 14,752
Bikes: Yes
Mentioned: 525 Post(s)
Tagged: 0 Thread(s)
Quoted: 3236 Post(s)
Liked 3,883 Times
in
1,443 Posts
I think the T.W is a date code.
__________________
My Bikes
My Bikes
#3
Junior Member
Thread Starter
#4
Senior Member
Join Date: Jul 2022
Location: Pac NW
Posts: 2,025
Bikes: several Eddy Merz (ride like Eddy, braze like Jim!)
Mentioned: 41 Post(s)
Tagged: 0 Thread(s)
Quoted: 1114 Post(s)
Liked 1,930 Times
in
698 Posts
Harbor Freight has really cheap calipers.
__________________
"Leave the gun. Take the Colnagos."
"Leave the gun. Take the Colnagos."
#5
Junior Member
Thread Starter
Good idea (I have calipers). For some reason I had figured that measuring the "hole" would not be helpful--but even with the bolt loose it's max 25.7 mm in diameter, so it's gotta be for 25.4 mm bars. Thanks.
Last edited by coffeecherrypie; 03-30-24 at 07:33 PM.
#6
Senior Member
Join Date: Jan 2008
Location: Beaverton, OR
Posts: 14,752
Bikes: Yes
Mentioned: 525 Post(s)
Tagged: 0 Thread(s)
Quoted: 3236 Post(s)
Liked 3,883 Times
in
1,443 Posts
If you have 26.0 bars, I'd see if they fit. A 25.4 might seem tight but slip in use. It looks like there might be a burr in the clamp area, so if 26.0 start to go in bit then snag it may just be that.
__________________
My Bikes
My Bikes