Resonance danger
#1
Senior Member
Thread Starter
Resonance danger
Hey guys, have you ever had your bike start to vibrate rhythmically? Normally I’ve seen this when riding without hands, and the handlebars start to shake and can quickly escalate into something dangerous. I think of this as resonance, and was very happy that my carbon road bike doesn’t seem to exhibit it, but after a few trips to the shop it now has developed a resonance.
Can someone who knows what I’m talking about expand on the phenomenon and suggest recourse, other than holding onto the handlebars?
thanks.
Can someone who knows what I’m talking about expand on the phenomenon and suggest recourse, other than holding onto the handlebars?
thanks.
Last edited by LarrySellerz; 04-11-24 at 11:54 AM.
Likes For Barry2:
#4
Grupetto Bob
Join Date: Sep 2020
Location: Seattle-ish
Posts: 6,950
Bikes: Bikey McBike Face
Liked 6,610 Times
in
3,342 Posts
The times it has happened to me, I was going over 40 MPH. Certainly gets your attention.
__________________
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
Likes For rsbob:
#5
On motorcycles its called “death wobble.” I’ve experienced it on both motorcycles and bicycles, and it can be a little hair-raising. There are some things you can do to minimize risk, make sure your headset isn’t loose, the axle bearings aren’t too worn, and balance your front wheel. Wheel balancing is easy. Put your bike in a stand and rotate your front wheel, let it turn freely, and see if the same side always comes to the bottom. Take a bicycle computer magnet, the kind which attaches to a spoke, and put it on a spoke on the opposite end. You can move the magnet up or down the spoke to change its effect on balance. The wheel is in balance when you can spin it, and it stops in any position randomly.
Likes For 50PlusCycling:
#6
Senior Member
Join Date: Jul 2009
Posts: 6,496
Bikes: Colnago, Van Dessel, Factor, Cervelo, Ritchey
Liked 8,298 Times
in
3,298 Posts
Putting your fingers in your ears should stop the resonance.
Likes For tomato coupe:
#7
Senior Member
Join Date: Jan 2014
Location: The banks of the River Charles
Posts: 2,051
Bikes: 2022 Salsa Beargrease, 2020 Seven Evergreen, 2019 Honey Allroads Ti, 2018 Seven Redsky XX, 2017 Trek Boon 7, 2014 Trek 520, 2006 Gary Fisher Montare
Liked 937 Times
in
497 Posts
Is this the same bike with the tire where the bead has separated from the sidewall?
#9
Senior Member
Does it happen when you see the chemtrails?...
Likes For wheelreason:
#10
Full Member
Join Date: Oct 2022
Location: UK, New Forest
Posts: 319
Bikes: 1980 Gitane sprint,1977 Motobécane C4, 1977 Carlton Clubman, 1959 Claud Butler European
Liked 148 Times
in
95 Posts
On motorcycles its called “death wobble.” I’ve experienced it on both motorcycles and bicycles, and it can be a little hair-raising. There are some things you can do to minimize risk, make sure your headset isn’t loose, the axle bearings aren’t too worn, and balance your front wheel. Wheel balancing is easy. Put your bike in a stand and rotate your front wheel, let it turn freely, and see if the same side always comes to the bottom. Take a bicycle computer magnet, the kind which attaches to a spoke, and put it on a spoke on the opposite end. You can move the magnet up or down the spoke to change its effect on balance. The wheel is in balance when you can spin it, and it stops in any position randomly.
Likes For awac:
#11
Senior Member
Join Date: Jan 2013
Posts: 2,831
Bikes: too many sparkly Italians, some sweet Americans and a couple interesting Japanese
Liked 677 Times
in
464 Posts
Was this on the bike you said on 4/8/24 "My back tube popped (tire is worn out so not going to try and replace tube) right as I was leaving work, I have to ride 6.5 miles home and then another 6.5 miles back to work before I can realistically fix it. I don’t think I have a narrow enough tire at home. It feels like a bucking bronco but it’s nothing unmanageable if I keep the speed down, luckily it’s just the back tire."?
Likes For easyupbug:
#12
Senior Member
Likes For Bald Paul:
Likes For Barry2:
#14
Likes For Steel Charlie:
#15
Senior Member
Join Date: Sep 2007
Location: Far beyond the pale horizon.
Posts: 14,576
Liked 1,498 Times
in
1,037 Posts
Hey guys, have you ever had your bike start to vibrate rhythmically? Normally I’ve seen this when riding without hands, and the handlebars start to shake and can quickly escalate into something dangerous. I think if this as resonance, and was very happy that my carbon road bike doesn’t seem to exhibit it, but after a few trips to the shop it now has developed a resonance.
Can someone who knows what I’m talking about expand on the phenomenon and suggest recourse, other than holding onto the handlebars?
thanks.
Can someone who knows what I’m talking about expand on the phenomenon and suggest recourse, other than holding onto the handlebars?
thanks.
Did you know there are ways of searching for stuff on the intertubes?
https://velo.outsideonline.com/road/...-to-stop-them/
#16
Klaatu..Verata..Necktie?
Join Date: May 2007
Location: SF Bay Area
Posts: 19,355
Bikes: Litespeed Ultimate, Ultegra; Canyon Endurace, 105; Battaglin MAX, Chorus; Bianchi 928 Veloce; Ritchey Road Logic, Dura Ace; Cannondale R500 RX100; Schwinn Circuit, Sante; Lotus Supreme, Dura Ace
Liked 13,203 Times
in
6,777 Posts
I got that once years ago my my Ritchey, coming down a short but fast non-technical descent. I hit 40 and the bike started wobbling and scared the hell out of me. I think it was the first time I'd gotten over 40 on it. I had only had the "5 Minute Fit". I took it in for a professional fit, where he dropped the bars, raised the saddle and moved it forward, which balanced my weight better, and it never recurred. I always credited the fit for solving the problem, but years later I read that wobble can be more of a random thing.
__________________
"Don't take life so serious-it ain't nohow permanent."
"Everybody's gotta be somewhere." - Eccles
"Don't take life so serious-it ain't nohow permanent."
"Everybody's gotta be somewhere." - Eccles
#17
Full Member
Join Date: Oct 2023
Posts: 429
Bikes: '00 LS Vortex/Chorus 12/Campag Zondas, '98 LS Classic/Chorus 10/Rolf Vector Pros
Liked 366 Times
in
209 Posts
I got that once years ago my my Ritchey, coming down a short but fast non-technical descent. I hit 40 and the bike started wobbling and scared the hell out of me. I think it was the first time I'd gotten over 40 on it. I had only had the "5 Minute Fit". I took it in for a professional fit, where he dropped the bars, raised the saddle and moved it forward, which balanced my weight better, and it never recurred. I always credited the fit for solving the problem, but years later I read that wobble can be more of a random thing.
#18
Too much weight forward of the steering center.
#19
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 13,325
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Liked 4,333 Times
in
2,789 Posts
Speed wobbles. 13ollocks describes them well. It is an oscillation caused by a driving force (that can be as simple as road vibration) and a system (Bike, wheels and rider) with a resonance of the same frequency (or harmonic of it). And it can vary from a minor scare to terrifying and high speed crash causing.
The cause is usually a combination of a particular bike and a particular rider. Sometimes simple changes are a permanent fix. Two things a rider should be aware of, one as a frequent cause of the wobbles and the other, usually a quick fix - the death grip on the handlebars; back off! Firm but NOT rigid! And the preventative/quick fix; place your knee on the top tube. That usually has a very large damping effect on the wobble.
I have one bike with the issue. Sadly my best custom that fits and rides like a dream. Recently I did a fast descent that while not absurdly fast, I have had to back off for the wobbles on the past. Tried lifting my butt a little off the seat with my legs a little more tensed, hands firmly in the drops with real weight on them and the bike stayed quiet. Haven't yet gone to the really fast hills trying that but I see that experience as encouraging.
The cause is usually a combination of a particular bike and a particular rider. Sometimes simple changes are a permanent fix. Two things a rider should be aware of, one as a frequent cause of the wobbles and the other, usually a quick fix - the death grip on the handlebars; back off! Firm but NOT rigid! And the preventative/quick fix; place your knee on the top tube. That usually has a very large damping effect on the wobble.
I have one bike with the issue. Sadly my best custom that fits and rides like a dream. Recently I did a fast descent that while not absurdly fast, I have had to back off for the wobbles on the past. Tried lifting my butt a little off the seat with my legs a little more tensed, hands firmly in the drops with real weight on them and the bike stayed quiet. Haven't yet gone to the really fast hills trying that but I see that experience as encouraging.
Likes For 79pmooney:
#20
climber has-been
Join Date: Dec 2004
Location: Palo Alto, CA
Posts: 7,510
Bikes: Scott Addict R1, Felt Z1
Liked 4,059 Times
in
1,999 Posts
On motorcycles its called “death wobble.” I’ve experienced it on both motorcycles and bicycles, and it can be a little hair-raising. There are some things you can do to minimize risk, make sure your headset isn’t loose, the axle bearings aren’t too worn, and balance your front wheel. Wheel balancing is easy. Put your bike in a stand and rotate your front wheel, let it turn freely, and see if the same side always comes to the bottom. Take a bicycle computer magnet, the kind which attaches to a spoke, and put it on a spoke on the opposite end. You can move the magnet up or down the spoke to change its effect on balance. The wheel is in balance when you can spin it, and it stops in any position randomly.
I think there are any number of factors that can initiate a speed wobble - road surface ruts, loose headset, unbalanced front wheel, etc - however, whether or not this relatively small input propagates/amplifies into a full-scale wobble is due to different factors, like F/R balance, "death-grip" on the bars, frame flex etc - factors that promote system resonance..
Last edited by terrymorse; 04-11-24 at 12:21 PM.
Likes For terrymorse:
#21
The Wheezing Geezer
Join Date: Oct 2021
Location: Española, NM
Posts: 1,266
Bikes: 1976 Fredo Speciale, Rivendell Clem Smith Jr., Libertas mixte
Liked 1,140 Times
in
542 Posts
Muscle tremors from other causes (nerve-related or due to exhaustion) are suspect too.
Climbers sometimes suffer from what they call "sewing-machine leg", which is no fun, either.
__________________
Beneath the valley of the underbikers.
Beneath the valley of the underbikers.
#22
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 13,325
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Liked 4,333 Times
in
2,789 Posts
Yup. And aging. Or, one of the best preventions is confidence. My bike that wobbles - only showed up once early on. On a cold ride with rain. Now, out of my early 50s and into my 70s, it is far worse. I carry warm clothes and stop and put them on for big descents even though I'll be on nice warm level ground in 10 minutes. On my other, non-wobble bikes I dress the compromise between comfort and convenience.
#23
Senior Member
Join Date: Mar 2023
Location: NorCal
Posts: 816
Bikes: Santa Cruz Blur 4 TR, Canyon Endurace cf sl, Canyon Ultimate cf slx, Canyon Strive enduro, Canyon Grizl sl8
Liked 1,558 Times
in
572 Posts
One of my road bikes is particularly susceptible to speed wobbles. I attribute it mostly to the 50mm wheels, as it will only start to pick up a shimmy at speeds above 40mph, with battling winds present. In dead calm conditions, I've confidently had that bike nearly to 60 w/o issue. I've tried changing my contact points when it starts to happen and keep a light touch on the bars, but nothing seems to fix it other than dropping below 40. Oddly enough, my other road bike with different 50mm rims, doesn't have the same issues. I can feel the wind pushing the bike, yet it doesn't develop the shimmy.
#24
Senior Member
A Resonance Cascade occurs when a Negative Mass Crystal is scanned by an Anti-Mass Spectrometer.
Although I will admit that the possibility of a resonance cascade scenario is extremely unlikely, I remain uncomfortable with the...
Although I will admit that the possibility of a resonance cascade scenario is extremely unlikely, I remain uncomfortable with the...
#25
Senior Member
Join Date: May 2010
Location: Bastrop Texas
Posts: 4,768
Bikes: Univega, Peu P6, Peu PR-10, Ted Williams, Peu UO-8, Peu UO-18 Mixte, Peu Dolomites
Liked 1,844 Times
in
1,182 Posts
So... Speed Wobble...
Front Brake or Back Brake?
As I remember on a Motorcycle it was feather the back brake...
__________________
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)