Issue with CS200cad (cadence)
#1
Member
Thread Starter
Join Date: Jul 2005
Posts: 35
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Issue with CS200cad (cadence)
Hi,
I purchased a CS200cad last summer. I have a lot of problem to have the cadence sensor working. Finally, after about 4 hours.. I made it worked... However, I removed it during the winter since I have installed my bike on a I-magic. Now, same problem.. can not make the cadence sensor work....
Anybody can give me tips?
Thanks
I purchased a CS200cad last summer. I have a lot of problem to have the cadence sensor working. Finally, after about 4 hours.. I made it worked... However, I removed it during the winter since I have installed my bike on a I-magic. Now, same problem.. can not make the cadence sensor work....
Anybody can give me tips?
Thanks
#2
Dirt-riding heretic
Join Date: Aug 2005
Location: Gig Harbor, WA
Posts: 17,413
Bikes: Lynskey R230/Red, Blue Triad SL/Red, Cannondale Scalpel 3/X9
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 5 Post(s)
Likes: 0
Liked 8 Times
in
7 Posts
Are you sure you have cadence turned on for the bike you've set up? That's the simplest...
Also, check the position of your magnet. It might be too far from the sensor.
DrPete
Also, check the position of your magnet. It might be too far from the sensor.
DrPete
#3
Senior Member
Join Date: Apr 2006
Posts: 305
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
you have to have the tiny little magnet very very very close to the sensor. I lost the magnet and bought a proprietry one from the LBS that was larger and allowed more leniancy