Rear wheel play
#1
Junior Member
Thread Starter
Join Date: May 2010
Posts: 10
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Rear wheel play
I noticed my rear wheel has some lateral play in it so I took out the axle and cleaned and re-lubed everything. The only way I can get the wheel to have no lateral play when the quick release is clamped down, is to tighten the axle so tight that it has resistance when spinning by hand. I cannot seem to find the happy medium of free spinning and no wobble and I have tried everything. Any thoughts on how to fix this or why it is doing this?
#4
Senior Member
Join Date: Jun 2002
Location: San Jose, CA
Posts: 3,691
Bikes: Too many bikes, too little time to ride
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 430 Post(s)
Liked 460 Times
in
318 Posts
Sometimes it can require a precise touch but it could also be your cones and/or bearings are worn and need replacement.
#5
Really Old Senior Member
Bent axle?
#6
Senior Member
Join Date: Dec 2019
Location: South Shore of Long Island
Posts: 2,799
Bikes: 2010 Carrera Volans, 2015 C-Dale Trail 2sl, 2017 Raleigh Rush Hour, 2017 Blue Proseccio, 1992 Giant Perigee, 80s Gitane Rallye Tandem
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 1088 Post(s)
Liked 1,024 Times
in
723 Posts
Bent axle or worn bits has others have mentioned, missing bearing from recent overhaul if that was done recently.
#7
Very Senior Member
Join Date: Mar 2018
Location: Always on the Run
Posts: 1,211
Bikes: Giant Quasar & Fuji Roubaix
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 413 Post(s)
Liked 343 Times
in
244 Posts
I've adjusted worn bearings so there's no slop and still roll somewhat smoothly and no play, but when I've unknowingly dropped a bearing during cleaning It gets more difficult to get the slop out (some call it preloading) and still have a smooth rolling wheel. Or somehow the axle got bent. Good luck
#8
Senior Member
Join Date: Feb 2012
Location: Golden, CO and Tucson, AZ
Posts: 2,837
Bikes: 2016 Fuji Tread, 1983 Trek 520
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 676 Post(s)
Liked 741 Times
in
430 Posts
Take a look at
for a fine-tuning technique. You'll need two cone wrenches and two lock nut wrenches.
#11
Senior Member
Join Date: Jan 2017
Posts: 1,064
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 350 Post(s)
Likes: 0
Liked 122 Times
in
90 Posts
If you mean that there is pitting on the cone then you might want to replace the cone and the balls. Balls are $2. Otherwise turning the pitted side upward would help increase the lifespan for the moment.