3 needle-nose tool? for 6400/01? freehub
#1
Senior Member
Thread Starter
3 needle-nose tool? for 6400/01? freehub
Attempting to break down the freehub.
After removing the axle and looking down the freehub, I can see the large ten ball bearings.
On the outside of here and slightly higher there is a ring shape with three small pinhole size holes spread like three points of a triangle.
RJ The Bike Guy has a freehub overhaul vid where he uses a homemade 2-hole tool to unwind a similar position ring.
Mine is definitely a 3-point/hole.
Any ideas what tool would be used for removal?
After removing the axle and looking down the freehub, I can see the large ten ball bearings.
On the outside of here and slightly higher there is a ring shape with three small pinhole size holes spread like three points of a triangle.
RJ The Bike Guy has a freehub overhaul vid where he uses a homemade 2-hole tool to unwind a similar position ring.
Mine is definitely a 3-point/hole.
Any ideas what tool would be used for removal?
#2
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 15,002
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6198 Post(s)
Liked 4,814 Times
in
3,321 Posts
Are you looking at the dust cover? I think you just use a hex key and remove the fixing bolt. Then pull on the free hub body and it should be off.
Shimano FH-6400 or FH-6401? Or is this some other brand since you said it was 6400/01?
A pic will help us know what you are seeing.
Found the SI's..
FH-6401 https://si.shimano.com/en/pdfs/si/T-...000-00-ENG.pdf
FH-6400 -7 and -6 https://si.shimano.com/en/pdfs/si/R-...000-00-ENG.pdf
Shimano FH-6400 or FH-6401? Or is this some other brand since you said it was 6400/01?
A pic will help us know what you are seeing.
Found the SI's..
FH-6401 https://si.shimano.com/en/pdfs/si/T-...000-00-ENG.pdf
FH-6400 -7 and -6 https://si.shimano.com/en/pdfs/si/R-...000-00-ENG.pdf
Last edited by Iride01; 03-25-24 at 07:23 AM.
Likes For Iride01:
#3
SE Wis
Join Date: Apr 2005
Location: Milwaukee, WI
Posts: 10,517
Bikes: '68 Raleigh Sprite, '02 Raleigh C500, '84 Raleigh Gran Prix, '91 Trek 400, 2013 Novara Randonee, 1990 Trek 970
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 2747 Post(s)
Liked 3,401 Times
in
2,058 Posts
If you're really inclined to disassemble the freehub you could make a tool like RJ but with 3 prongs.