Dynamo hub dont work
#1
Junior Member
Thread Starter
Join Date: Jun 2018
Posts: 5
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Dynamo hub dont work
Alfine Dynamo Hub DH-S50 when it rotate very slowly produce power but in hight speed it stop working does you guys knows why this happens
#2
Senior Member
Join Date: Mar 2018
Location: Indiana
Posts: 121
Bikes: Felt Z5, Look 675 Light, Specialized Diverge
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 48 Post(s)
Likes: 0
Liked 2 Times
in
1 Post
That, of course, is the opposite behavior from what you should be seeing. When you say, "high(t) speed", what do you mean? A bicycle wheel doesn't really rotate all that quickly. Says 100-400 RPM or so.
It sure sounds like there is some defect or fault in the hub.
It sure sounds like there is some defect or fault in the hub.
#3
Senior Member
Join Date: Aug 2010
Location: Madison, WI
Posts: 11,204
Bikes: 1961 Ideor, 1966 Perfekt 3 Speed AB Hub, 1994 Bridgestone MB-6, 2006 Airnimal Joey, 2009 Thorn Sherpa, 2013 Thorn Nomad MkII, 2015 VO Pass Hunter, 2017 Lynskey Backroad, 2017 Raleigh Gran Prix, 1980s Bianchi Mixte on a trainer. Others are now gone.
Mentioned: 48 Post(s)
Tagged: 0 Thread(s)
Quoted: 3459 Post(s)
Liked 1,465 Times
in
1,143 Posts
When you say it stops working at higher speeds, how do you know that? I recall reading a review a few years ago of a dyno powered USB charger that when the dynohub put out too much power (from going down a hill or something) the USB charger shut down to avoid overloading the circuits. Could the device you have hooked up to the hub be the problem and not the hub itself?
On my hub with nothing attached to it other than a volt meter (one that measured AC), I measured over 30 volts going down a hill at 25 mph. That was why that USB charger was designed to cut out at higher speeds.
On my hub with nothing attached to it other than a volt meter (one that measured AC), I measured over 30 volts going down a hill at 25 mph. That was why that USB charger was designed to cut out at higher speeds.