Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: unterhausen
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: Framebuilders
04-09-21, 09:53 AM
Replies: 23
Views: 25,663
Posted By unterhausen

Some of the people in this thread that made posts...

Some of the people in this thread that made posts that might inflame others are no longer around to defend themselves so I'm going to close it.
Forum: Framebuilders
04-09-21, 07:11 AM
Replies: 23
Views: 25,663
Posted By unterhausen

The OP tried it, he posted pictures just a little...

The OP tried it, he posted pictures just a little bit up the thread.

The thread was bumped by a spammer, it's a zombie thread


I touched on the conservatism angle a couple of times in this...
Forum: Framebuilders
04-08-21, 05:40 PM
Replies: 23
Views: 25,663
Posted By unterhausen

Welcome to the forum. Sorry your post didn't...

Welcome to the forum. Sorry your post didn't show up right away. You can see his frame above and there is a link to another thread showing it as a bike.


There have to be good reasons why...
Forum: Framebuilders
04-08-21, 08:48 AM
Replies: 23
Views: 25,663
Posted By unterhausen

You quoted a spammer. How's that frame holding...

You quoted a spammer. How's that frame holding up?

I didn't read through the thread to see if I knew this back in 2010, but some recumbent manufacturers use MIG. I think it's mostly for thick...
Forum: Framebuilders
03-29-10, 10:40 PM
Replies: 23
Views: 25,663
Posted By unterhausen

If you become an expert at it you can come back...

If you become an expert at it you can come back here and answer questions. I think many people here hate seeing unanswered questions, I know I do.
Forum: Framebuilders
03-28-10, 07:25 PM
Replies: 23
Views: 25,663
Posted By unterhausen

Distortion is a real problem with any process. ...

Distortion is a real problem with any process. But the real issue about asking this question in this forum is that nobody that posts here on a regular basis uses MIG on bike frames. So we're all...
Forum: Framebuilders
03-25-10, 12:15 PM
Replies: 23
Views: 25,663
Posted By unterhausen

made me laugh

made me laugh
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.