Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: ThisJustIn
Showing results 1 to 11 of 11
Search took 0.01 seconds.
09-17-22, 03:49 PM
Replies: 8
Views: 260
Posted By Andrew R Stewart

The usual goal with a question about raising the...

The usual goal with a question about raising the stem is to actually have the hand holding location (the grips on a non drop bar) higher. This can be had by a few methods.

One has been mentioned,...
09-17-22, 03:29 PM
Replies: 8
Views: 260
Posted By SoSmellyAir

The height of the handlebar cannot be raised from...

The height of the handlebar cannot be raised from what is shown in the above photograph without buying a new stem.

Either (or both) of the spacers below the stem may be removed and reinstalled...
Replies: 14
Views: 367
Posted By Peroni

If you do want to clean some of the dirt off of...

If you do want to clean some of the dirt off of it, don't blast it with a hose and degreaser, nothing is really sealed against water and degreaser or detergent very much.
A can of Moto spray polish...
Replies: 14
Views: 367
Posted By T-Mar

The subject bicycle is a Bertrand 3000, circa...

The subject bicycle is a Bertrand 3000, circa 1985-1987. Bertrand was essentially the house brand for Cycles Bertrand, a small retail shop based in Hull Quebec, that started in the very early 1960s....
Replies: 14
Views: 367
Posted By Peroni

It's a large frame, too much larger the 58cm for...

It's a large frame, too much larger the 58cm for me to be able to ride at all. I would start guessing at $1000 since the drive train looks like new, but I'm Newbie and don't know very much.
I see...
08-12-22, 09:40 AM
Replies: 8
Views: 455
Posted By Daniel4

Yeah, I know what you mean. Ideally, the camera...

Yeah, I know what you mean. Ideally, the camera should be at eye-level so you record what you're looking at. My camera is about 4 to 6 inches above my eye. So I have to tilt it up abit to record...
08-07-22, 05:57 PM
Replies: 8
Views: 455
Posted By rumrunn6

been very happy w/ a refurb'd GoPro8 off Amazon....

been very happy w/ a refurb'd GoPro8 off Amazon. mounting anything, anywhere, is a task. I'm all set but my mount is custom so I can't recommend it for others. but I like it mounted to the front of...
08-07-22, 05:49 PM
Replies: 8
Views: 455
Posted By RGMN

Drift Ghost XL Pro...

Drift Ghost XL Pro (https://us.driftinnovation.com/collections/cameras-new/products/ghost-xl-pro) are popular for helmet mounting
Replies: 14
Views: 451
Posted By Bianchigirll

Oh yes this bike is a hard pass at 460. ...

Oh yes this bike is a hard pass at 460.

paper thin dropouts like this are a dead giveaway to a lowend bike. Although there are plenty of older very nice bikes that donít a derailleur hanger...
Forum: Touring
07-26-22, 09:17 AM
Replies: 29
Views: 1,757
Posted By Prowler

I was pretty late to the party but got it done....

I was pretty late to the party but got it done. In 2019, at 67 yrs old, I took my first tour. I'd become interested in the GAP and, as I told my wife, "I'm not getting any younger" and no way to tell...
Forum: Touring
06-19-22, 06:40 PM
Replies: 29
Views: 1,757
Posted By mev

I wrote up a brief synopsis as an introduction to...

I wrote up a brief synopsis as an introduction to my bike touring book - copied it below...

Fully working brakes can't be that important. After the brakes slow you down enough, then you put your...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2022 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.