Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: USMCRet
Showing results 1 to 6 of 6
Search took 0.01 seconds.
09-27-20, 12:23 PM
Replies: 13
Views: 602
Posted By freeranger

Maybe put a dab of epoxy on the hex wrench and...

Maybe put a dab of epoxy on the hex wrench and allow it to sit overnight in the hex screw, then turn it out in the morning. Just be sure no epoxy goes anywhere you don't want it, and of course,...
09-27-20, 10:43 AM
Replies: 13
Views: 602
Posted By Iride01

Just looked at some Tektro brakes. Don't know...

Just looked at some Tektro brakes. Don't know for certain which yours are but all the screws that you can see in pictures are Torx. Perhaps yours isn't messed up too bad yet.
09-27-20, 10:38 AM
Replies: 13
Views: 602
Posted By Amt0571

Use a dremel to make a cut in the screw head. Use...

Use a dremel to make a cut in the screw head. Use a flat screwdriver to remove the screw.
09-27-20, 10:36 AM
Replies: 13
Views: 602
Posted By Iride01

Heat from a torch will make a bad situation...

Heat from a torch will make a bad situation worse. Don't do it.
09-27-20, 10:33 AM
Replies: 13
Views: 602
Posted By Troul

remove the caliper with bracket from the bicycle,...

remove the caliper with bracket from the bicycle, put it in a vise & use a left hand drill bit in the center of the retaining screw.
09-27-20, 09:55 AM
Replies: 13
Views: 602
Posted By cxwrench

I'd probably try drilling the head of the...

I'd probably try drilling the head of the retaining screw off and going from there. It might allow you to remove the screw w/ needle nose pliers or if that won't work maybe drill/easy out.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.