Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: CliffordK
Showing results 1 to 3 of 3
Search took 0.01 seconds.
12-05-16, 03:47 PM
Replies: 37
Views: 3,357
Posted By CliffordK

I re-cut my Campy NR bottom bracket spindle cones...

I re-cut my Campy NR bottom bracket spindle cones on a lathe... whew.. that was HARD. So grinding stone might be preferable.

You will make the cones narrower, but you can make up for that...
12-05-16, 03:32 PM
Replies: 37
Views: 3,357
Posted By CliffordK

I think one of the Shimano generator hubs also...

I think one of the Shimano generator hubs also had a 11mm cone, but had a bit of an odd shape to it.

Eventually I'll pull that wheel that I've been regularly re-adjusting apart. Maybe in the next...
12-05-16, 03:10 PM
Replies: 37
Views: 3,357
Posted By CliffordK

Ideally, I think the bearings should ride at...

Ideally, I think the bearings should ride at about the 45 point on both the cones and races.

If clearance is too low or too high, it may push the balls either further up or further down on the...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.