Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
Search: Posts Made By: maddog34
Showing results 1 to 6 of 6
Search took 0.00 seconds.
Forum: Bicycle Mechanics
03-24-23, 11:13 PM
Replies: 30
Views: 691
Posted By maddog34

I'd advise using a lightweight Grease too! Too...

I'd advise using a lightweight Grease too! Too thick a grease will prevent fast movement of the pawls... so... Light coating of Lightweight grease on the Pawls... the Same Lightweight grease should...
Forum: Bicycle Mechanics
03-24-23, 04:17 PM
Replies: 30
Views: 691
Posted By maddog34

yes. Holding the special 4 prong removal socket...

yes. Holding the special 4 prong removal socket in a large Bench Vise then using the Rim to turn the wheel is the preferred method.. and If there is a bike shop near you, i'd advise stopping in and...
Forum: Bicycle Mechanics
03-24-23, 03:26 PM
Replies: 30
Views: 691
Posted By maddog34

And..if it's Not a metal dust coverpressed onto...

And..if it's Not a metal dust coverpressed onto the cone, it would be a thin seal that''s lightly pressed into the Hub.. and the axle would fall out on it's own.......
Forum: Bicycle Mechanics
03-24-23, 03:21 PM
Replies: 30
Views: 691
Posted By maddog34

i'd suggest that you tear down a Formula Chinese...

i'd suggest that you tear down a Formula Chinese knockoff hub some time...;-)

and also Measure some of the parts you're claiming Knowledge about.

i did.
Forum: Bicycle Mechanics
03-23-23, 07:54 PM
Replies: 30
Views: 691
Posted By maddog34

really? huh.. i just dug out three old 4 prong...

really? huh.. i just dug out three old 4 prong freewheels... Complete Axle Sets, including the cones(slightly smaller than the 17mm hex locknuts,btw) pass right through them as long as the dust...
Forum: Bicycle Mechanics
03-23-23, 04:31 PM
Replies: 30
Views: 691
Posted By maddog34

the thing retaining the axle in the hub is a...

the thing retaining the axle in the hub is a simple metal dust cover.. tap on the non-drive end of the axle with a soft hammer.clean and re-grease the bearing areas on both sides of the hub... Clean...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.