Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: reroll
Showing results 1 to 7 of 7
Search took 0.01 seconds.
12-28-22, 08:35 PM
Replies: 14
Views: 362
Posted By reroll

In 1981 rear dropout spacing was almost always...

In 1981 rear dropout spacing was almost always 126mm and an 8-speed free hub or freewheel requires at least 130mm spacing.
10-18-22, 07:25 PM
Replies: 12
Views: 813
Posted By reroll

Not sure I could give myself credit for an...

Not sure I could give myself credit for an exposition, and I have used a range of stems from fairly long to quite short, but I was curious to see if there could be any sort of a formula or...
10-18-22, 02:23 AM
Replies: 12
Views: 813
Posted By reroll

The long and the short about stem lengths

I searched online for advise about stem lengths and what I thought would be simple turned out to be complicated. I am a commuter, grocery getter and occasional tourist, but learned a lot about stem...
08-14-22, 05:14 PM
Replies: 19
Views: 574
Posted By reroll

Just the info I needed, the Sheldon dropout...

Just the info I needed, the Sheldon dropout alignment check photo, at just the right time, thank you!

Bought a vintage frame set, being shipped to me now, and I wanted to do an alignment check on...
07-22-22, 05:52 AM
Replies: 32
Views: 710
Posted By reroll

Once upon a time there were 5-speed hubs which...

Once upon a time there were 5-speed hubs which fit into 120mm dropouts and then efforts were made to fit 6 speeds into 120mm, the narrow Ultra freewheels, for instance. But they met with only limited...
07-03-22, 02:57 PM
Replies: 24
Views: 1,042
Posted By reroll

Restoration could cost more than the cost of a...

Restoration could cost more than the cost of a new bike, yet about ten feet away from me is a 1983 lugged steel frame bike which was in near perfect condition but about to go away in a dumpster and...
07-03-22, 01:54 PM
Replies: 22
Views: 889
Posted By reroll

Microshift components 2022

Shimano has largely turned away from producing high chain/tooth capacity 7/8/9-speed derailleurs and triple chainsets in favour of 10/11/12-speed technologies yet those earlier technologies do have...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.