DIY Carrier For Dual Wire BOA
I used the rubber crank arm carrier with the sensor inserted, some fine 7mm cable ties and a small hook and loop strap to get a an adaptation that suits my Specialized BOA shoes.
I passed the small cable ties through the cable holes at each the end of carrier and locked each into a small loop. If you live in the UK you can buy a pack of 6x Velcro straps in an assortment of colours for £2.50 from Wilco.
I passed the strap through the cable tie loops and then round the BOA wires so that sensor sits in the correct N-S position. The strap is doubled over and locks in place. See photo. I tried it for the first time today - it was secure with no flapping. With the hook and loop the carrier can be easily removed when I use the shoes on the turbo.
I will experiment with neater set-up, but so far everything is working well. I hope this helps anyone else left scratching their head in this predicament.
Sorry I can’t upload my photos as I haven’t left 10 posts.! 😟
Last edited by jansell; 06-11-23 at 11:05 AM.