Originally Posted by
Bill Kapaun
What type of gear train? 1X, 2X, 3X?
Are you easing up pressure when you shift?
Monster sized cogs like an 11-40 or worse?
The shift wire may have "worn in" a bit.
Try turning the barrel adjuster on the RDER CCW 1 click & test.
KEEP TRACK of clicks.
If this improves or no change, add 1 more click & repeat.
At this point, things should get bad or better. If bad, go back to zero and try the other direction.
Tiagra
11-34 , 50-34
Yes, I do ease shifts, but its not always milk and butter when you are training hard.
Originally Posted by
zandoval
As to the OP: Be sure to check the cogs on your Freewheel/Cassette. Remove the wheel then check each cog by grabbing it and rocking it back and forth. On a freewheel ya get a Cluck. Rats I hate clocks and pings, especially if I dont know where they come from...
Didnt quite get what should I check about cogs? They are clean.