View Single Post
Old 07-26-22, 09:50 PM
  #1  
tulsarob
ebiker
 
Join Date: Jul 2022
Location: Oklahoma
Posts: 28

Bikes: engwe 750 engine pro

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 9 Post(s)
Likes: 0
Liked 12 Times in 7 Posts
bike stem solution

I made a drawing but can't post it yet. On my engwe 750 engine pro I have 21mm available steering tube length to mount my 30mm thick stem. The upper stem mounting bolt centerline is in line with the top of the steering tube.

I'm thinking about putting a steering tube diameter spacer below the top cap to support the upper stem bolt compression with a slight gap below the top cap rim. Not sure I need this though. I don't do jumps or hills, just ride around a local sporting clay course on a gravel path. Think this will work?

Wish I could post the drawing, might make things clearer.

I havn't measured the rim dia of the top cap, not sure the stem will compress on it. It seemed like a sloppy fit.

Last edited by tulsarob; 07-26-22 at 09:52 PM. Reason: added to it
tulsarob is offline