LED installation
No RTV silicon involved. I kept sanding off plastic on the headlight housing until it slide inside the RADIOS housing. It is a sung fit and takes a bit of wiggling to get it back out. It took a lot more sanding than I thought it would. A dremel tool with sanding drums are a must. It would take much longer if sanded by hand. There is a nut that holds the top of spring loaded latch that needs to be cleared. Plus, there are a couple of rivets in the bottom of the Radios housing that need to be cleared as well. I was able to run the wires out through an existing hole in the Radios housing. It was a slow process of sanding and test fitting.