View Single Post
Old 11-21-22, 10:25 AM
  #1  
Gosh
Newbie
 
Join Date: Nov 2020
Posts: 19
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 3 Times in 2 Posts
Problems with rear caliper brake set up

I’ve been struggling with keeping the arms/pads from rubbing on one side of my rear brakes Shimano 105 caliper brake. When depressing/letting off the break the non spring side /drive side (other side from cable attachment) doesn’t open sufficiently to take up all the cable slack. The arm opens when I push down on the end. Please see video attached. I have just changed the housing and cable, thinking that might be the problem and the housing end are fully inserted into lever and ferrules, there are no burrs on the housings. It is though the cable housing isn’t springing back all take up all the cable. I would be grateful for some suggestions of how to fix or what I’ve been doing wrong. Thanks
Gosh is offline