View Single Post
Old 07-18-21, 02:20 PM
  #9  
oneclick 
Senior Member
 
Join Date: Feb 2020
Posts: 2,887
Mentioned: 49 Post(s)
Tagged: 0 Thread(s)
Quoted: 1103 Post(s)
Likes: 0
Liked 1,308 Times in 773 Posts
Originally Posted by bikemig
That's news to me. I thought that the older stronglight cranks all required a stronglight puller which is different than a TA. They're close enough that you can use them interchangeably even though it's a bad idea to do so.

I know the last time I worked on a bike with the crank on the OP's bike I used the early Stronglight puller. That doesn't mean it was the right puller. But I thought it was,
Using a 23mm on a 23.35mm crank will usually only pull the threads off.

But it's a good thing you made me check the version of that crank that's on a bike in the shed; it takes a 22mm. If you got a 23.35 in there then either they made both sizes, or you has *big* arms.
oneclick is offline