Originally Posted by
Geepig
Is that lever at the top in the right body, or the right way around in that body?
It has that rectangular block on the side, which slides into a slot in the body, but the slot only looks deep enough to accept the block if the lever had the cable passing through it from the other direction.
As I mentioned in Post #8, I managed to get the lever installed onto the body. However when I move the lever to any other position other than the one shown in this new image the lever snaps back to its original position.
Thus my questions are:
#1. Is that normal?
#2. Is it only when the cable is attached to the derailleur that the lever stays in a position it is moved to?
Thanks again and cheers