Thread
:
Chinese out front combo mount
View Single Post
05-02-22, 03:15 PM
#
2
RichSPK
Full Member
Join Date: Jul 2010
Location: Worcester, MA, USA
Posts: 411
Bikes:
Dawes Lightning DLX, 1988 Klein Performance, 1991 Peugeot Safari, 1985 Raleigh Alyeska, Carrera Phantom, 1973 Raleigh Record
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 282 Post(s)
Likes: 2,639
Liked 129 Times in
92 Posts
Contents of hardware bag showing opposite side of sheet of pre-cut self adhesive pads
Note that I didn't use the self-adhesive rubber pads. I'm not sure where they're intended to be used, but I'm guessing you stick them inside the clamping jaws, between the mount and the handlebar.
Use the medium panhead screw and (1) split lockwasher here, securing it around the handlebar
The GoPro plate bolts to the underside of the mount with the (2) small panhead screws and (2) split lockwashers. The large panhead screw goes through the side of the GoPro plate.
The Garmin or Bryton plate bolts to the top of the mount using the (2) flathead screws. Don't try to use lockwashers with flathead screws. You'll have (2) spare lockwashers.
Riders view of mount
The mount is sized for larger bars than mine, so I cut up an old inner tube to shim it
Side view of mount
Front view of mount
Three quarters view of mount
Reply
RichSPK
View Public Profile
Visit RichSPK's homepage!
Find More Posts by RichSPK