Originally Posted by
Troul
increase the wheel's roller preset resistance.
I have no idea why I’d do that. It works fine as is.
I have it set up per the manual, which is 2 full turns after contact plus an additional 1/4 turn. Tires (28mm) are at 80 psi. I don’t get any slipping. Trainer is a Kickr Snap.
Tire wear is a non-issue with my setup. Maybe I’m just lucky? I have ridden this same tire both inside and outside.
I have an old cyclops fluid trainer as well. I never noticed any unusual tire wear on that either, but I also didn’t ride it all that often.