Old 02-12-21, 05:26 PM
  #22  
sapporoguy
Full Member
 
sapporoguy's Avatar
 
Join Date: Mar 2015
Location: San Francisco
Posts: 259

Bikes: 2000 Santana Sovereign SE; 2005 Co-Motion Speedster; Kona Kilauea with various dorky commuter accoutrements; Mercier Kilo TT fixie; Burley Fladbed trailer for groceries, bags of cement and the like.

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 95 Post(s)
Likes: 0
Liked 85 Times in 41 Posts
Originally Posted by PoeCo
This is my suspicion. I think it has something to do with one of the BBs... so, either the one we replaced is just a bad one, or it's the captain's BB that has gone bad.
We had an infuriating noise that sounds a lot like this, which seemed to be coming from the back. I'd replaced stoker BB so sure wasn't that and had spun the pilot's cranks without chain and it spun freely with no play. I did just about everything possible--pedals, skewers, whatnot.
Then I took off the front crank and spun the righthand bb bearing with a finger--too tight! And there signs it was so tight the shaft was sometimes slipping inside the bearing race under certain conditions. replaced front BB and noise was gone.
sapporoguy is offline