Originally Posted by
Iride01
Got a marine store near you with a lot of rigging supplies? The 3/64ths version of this might work. 3/64 of an inch is only about 3 thousandths bigger than a 1.1 mm shift cable. I've never seen any this small at HD or Lowes, but I've never looked for very small ones.
https://www.jamestowndistributors.co...uct.do?pid=288
Crimping properly without crimpers might be an issue though. I'd use at least two.
I'd try doubling them up. up one side down the other both directions. each end would be a "J" on both tubes of the crimp. No reason it shouldn't work in a uncased area of the cable if it can't hang up on something on the frame.