Originally Posted by
cyclic_eric
Perhaps I'll get lucky and happen upon the ratcheting 10mm wrench that SurferRosa didn't pick up! I have a non-bending ratcheting 10mm wrench, not the one Andy_K recommends.
It's been a few years, but it was in the Crown Hill neighborhood on 8th avenue, I believe. You might try there.
But the one you already have is just like it and works fine ... on the rear bolt.
One of the seatposts I bought had a replacement bolt that wasn't Campy. It was long (before I cut it down), and the bolt head had a taller profile than normal. So possibilities are out there. If you have a place like this, try there if necessary:
https://www.tacomascrew.com/
If it's threaded and made of metal, they have it.