View Single Post
Old 08-05-22, 12:59 PM
  #10  
CliffordK
Senior Member
 
CliffordK's Avatar
 
Join Date: Nov 2014
Location: Eugene, Oregon, USA
Posts: 27,268
Mentioned: 215 Post(s)
Tagged: 0 Thread(s)
Quoted: 16724 Post(s)
Liked 3,727 Times in 2,767 Posts
OK,
So your break is a good distance away from where it is brazed, and you should be able to weld it without damaging the brazed joint. Some people will use a damp rag to prevent overheating.

I'd probably just grind in a deep V, then weld it up. TIG? Carefully cutting/filing a gusset to go in the triangle is a good idea, but may not be vital, and would certainly increase the heat affected area. You'll do best if any welding is ground back flush with the machined part of the dropout.
CliffordK is offline