Thread: Best Rear Light for $25?
View Single Post
Old 02-02-22, 07:03 PM
  #144  
hotbike
Senior Member
 
hotbike's Avatar
 
Join Date: Dec 2006
Location: Long Island, New York
Posts: 3,751

Bikes: a lowrider BMX, a mountain bike, a faired recumbent, and a loaded touring bike

Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
Quoted: 256 Post(s)
Liked 90 Times in 75 Posts

Front and rear are cut from another piece of Coroplast (or similar corrugated polypropylene) keeping the grain horizontal.



The pattern for the sides, bottoms, and wheel arch. You could conceivably cut two of these from one 48” by 96” sheet, if you fudge it a little bit, I’m leaving two inches of flap to fold over and glue…



Pattern with locations marked Blue lines cut Red lines fold



Pattern with measurements marked in millimeters (And I spelled “height” wrong)
hotbike is offline  
Reply
Likes For hotbike: