Home Made Handlebars Material Selection Help
#1
Newbie
Thread Starter
Join Date: May 2015
Posts: 16
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
Home Made Handlebars Material Selection Help
Hi everyone. I would like to bend my own handlebars for personal use. I have a Diacro bender and I have made some dies for it.
I was planning to use .049” chromoly from Aircraft Spruce but I’m wondering if .049” is too heavy/overkill for handlebars? I weigh 150lbs and the handlebars will be used on a city bike.
I was planning to use .049” chromoly from Aircraft Spruce but I’m wondering if .049” is too heavy/overkill for handlebars? I weigh 150lbs and the handlebars will be used on a city bike.
Likes For degull:
#2
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,075
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4201 Post(s)
Liked 3,859 Times
in
2,307 Posts
IIRC Tioga used .035 walled bars back in the day. Steel bar failures are rare and usually able to see the seeds of cracks before the catastrophic happens. How wide will your bars be? How will the stem clamp diameter spec be handled? Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For Andrew R Stewart:
#3
Newbie
Thread Starter
Join Date: May 2015
Posts: 16
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
I don’t have any chromoly handlebars to measure the wall thickness. I have .035” wall so I might give it a try.
Last edited by degull; 10-31-22 at 10:09 AM.
#4
Senior Member
Join Date: Oct 2014
Location: Reno nevada
Posts: 786
Bikes: a few that I can't recall
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 344 Post(s)
Liked 300 Times
in
146 Posts
The weight difference between 035 and 049 is not worth how much worse the bends will look if not using a mandrel bender.