Shimano Shifting Question
#1
OldSchool
Thread Starter
Shimano Shifting Question
Not so much of a Shimano guy, and I have a question about Shimano shifting levers. Do Shimano dual control indexed handlebar levers handle both double and triple cranksets or are there 2 ring and 3 ring specific models? I would be interested in knowing about Dura Ace, Ultegra, and 105 only and I am interested in 8 speed or 9 speed levers. Thank you very much.
Last edited by cpsqlrwn; 06-26-22 at 10:54 AM.
#2
Senior Member
Join Date: Mar 2007
Location: SF Bay Area, East bay
Posts: 7,658
Bikes: Miyata 618 GT, Marinoni, Kestral 200 2002 Trek 5200, KHS Flite, Koga Miyata, Schwinn Spitfire 5, Mondia Special, Univega Alpina, Miyata team Ti, Santa Cruz Highball
Mentioned: 53 Post(s)
Tagged: 0 Thread(s)
Quoted: 1609 Post(s)
Liked 2,590 Times
in
1,224 Posts
Most are specific, 2 or 3, but some models do both. Best to include gearing, 8 9 10 +...
#3
Ride, Wrench, Swap, Race
Join Date: Jan 2010
Location: Northern California
Posts: 9,193
Bikes: Cheltenham-Pedersen racer, Boulder F/S Paris-Roubaix, Varsity racer, '52 Christophe, '62 Continental, '92 Merckx, '75 Limongi, '76 Presto, '72 Gitane SC, '71 Schwinn SS, etc.
Mentioned: 132 Post(s)
Tagged: 0 Thread(s)
Quoted: 1565 Post(s)
Liked 1,295 Times
in
865 Posts
I have successfully used triple-specific left STI levers to operate normal double arrangements. The trick was to set it up using the shifter's 1st and 2nd detents, with the 3rd detent locked out against the hi-limit screw.
Also, there won't be fully-functioning trim positions at the big-ring position, but which can be adjusted around with fine-tuning (and/or by very slightly widening the cage width near the front of the cage). Done this many times actually.
Also, there won't be fully-functioning trim positions at the big-ring position, but which can be adjusted around with fine-tuning (and/or by very slightly widening the cage width near the front of the cage). Done this many times actually.