where do all the pedal end caps go??
#1
Senior Member
Thread Starter
Join Date: Jul 2022
Location: Pac NW
Posts: 1,910
Bikes: several Eddy Merz (ride like Eddy, braze like Jim!)
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 1040 Post(s)
Liked 1,698 Times
in
624 Posts
where do all the pedal end caps go??
Atlantis?
The moon?
With the missing socks?
finished a ride between raindrops and looked down, cap was missing. Then I remembered that brand new pair in the box I picked up recently. The drivers side was missing it's cap too.
Where do they go?
The moon?
With the missing socks?
finished a ride between raindrops and looked down, cap was missing. Then I remembered that brand new pair in the box I picked up recently. The drivers side was missing it's cap too.
Where do they go?
__________________
"Leave the gun. Take the Colnagos."
"Leave the gun. Take the Colnagos."
Last edited by Robvolz; 01-09-23 at 02:59 PM.
#2
Senior Member
Join Date: Feb 2020
Posts: 2,890
Mentioned: 49 Post(s)
Tagged: 0 Thread(s)
Quoted: 1103 Post(s)
Likes: 0
Liked 1,309 Times
in
773 Posts
Caps with serrated edges that stand proud of the barrel into which they are screwed, will un-screw as you insert or remove your foot.
Use a thread-locker on them.
Use a thread-locker on them.
#3
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,830
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 128 Post(s)
Tagged: 0 Thread(s)
Quoted: 4743 Post(s)
Liked 3,860 Times
in
2,509 Posts
I used to ride the Leotard platforms on my Peugeot UO-8 fix gear. I never knew where those left caps went but I did know why. That UO-8 BB, already low - part of the ride people love so much - got lowered further with 700c sewup wheels. Quite a bit. Even though I rode 168 cranks, touching them on corners just meant i took that corner faster than an old lady. And every touch of the left pedal was a drag back on the bottom of that right-hand threaded cap. (If only Leotard could have done those left pedals up "right" and provided dust caps with left-hand threads! I have a box of old, dead platforms with no caps (the press fit assembly doesn't hold up with the required pulling to get up say Seattle's east-west streets). Every pair went onto the box with just one cap which got robbed to feed the next set.)
#4
Senior Member
Join Date: Feb 2013
Location: Alta California
Posts: 14,324
Mentioned: 414 Post(s)
Tagged: 1 Thread(s)
Quoted: 3781 Post(s)
Liked 3,284 Times
in
2,145 Posts
-----
thar ha' been occasions where ah encountered them in the roadway, the gutter and/or in the parkway strip
one needs to catch 'em befor' they gits runned ovuh as they be not much guud afta...
-----
thar ha' been occasions where ah encountered them in the roadway, the gutter and/or in the parkway strip
one needs to catch 'em befor' they gits runned ovuh as they be not much guud afta...
-----
Likes For juvela:
#5
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,830
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 128 Post(s)
Tagged: 0 Thread(s)
Quoted: 4743 Post(s)
Liked 3,860 Times
in
2,509 Posts
Another way to think about this. Suppose you were a dust cap? Would you rather spent your life screwed to a cold bar of aluminum, getting to go out in nature periodically, only to spend hours just spinning in circles? Or suppose you could detach, roll off tho the street edge, hang out with pebbles your size and commune with earthworms and other gentle souls?
Likes For 79pmooney:
#6
Senior Member
Join Date: Jul 2006
Location: San Jose (Willow Glen) Ca
Posts: 9,854
Bikes: Kirk Custom JK Special, '84 Team Miyata,(dura ace old school) 80?? SR Semi-Pro 600 Arabesque
Mentioned: 104 Post(s)
Tagged: 0 Thread(s)
Quoted: 2304 Post(s)
Liked 2,739 Times
in
1,498 Posts
same place as socks go.
__________________
Life is too short not to ride the best bike you have, as much as you can
(looking for Torpado Super light frame/fork or for Raleigh International frame fork 58cm)
Life is too short not to ride the best bike you have, as much as you can
(looking for Torpado Super light frame/fork or for Raleigh International frame fork 58cm)
Likes For squirtdad:
#7
I don't know.
Join Date: May 2003
Location: South Meriden, CT
Posts: 1,976
Bikes: '90 B'stone RB-1, '92 B'stone RB-2, '89 SuperGo Access Comp, '03 Access 69er, '23 Trek 520, '14 Ritchey Road Logic, '09 Kestrel Evoke, '08 Windsor Tourist, '17 Surly Wednesday, '89 Centurion Accordo, '15 CruX, '17 Ridley X-Night
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 306 Post(s)
Liked 822 Times
in
430 Posts
I don't know what the pedal caps look like, so this might not be a valid question, but; could pedal caps be a good 3D printing project? I'm always looking for small parts to make.
I made these drop out spacers recently. They are replicas of what came on my 1988 Centurion. The bike was missing one when I got it. The originals were white.
I made these drop out spacers recently. They are replicas of what came on my 1988 Centurion. The bike was missing one when I got it. The originals were white.
#8
Senior Member
Join Date: Feb 2013
Location: Alta California
Posts: 14,324
Mentioned: 414 Post(s)
Tagged: 1 Thread(s)
Quoted: 3781 Post(s)
Liked 3,284 Times
in
2,145 Posts
-----
once saw a single panel cartoon wish had saved
two astronauts/spacemen are standing on the cratered surface of some planet or moon
the landscape is a rather uniform one of small craters
the only thing on the surface are these dark boomerang shapes about a foot long
one astronaut says to the other - "So this is where all the missing socks go!"
-----
once saw a single panel cartoon wish had saved
two astronauts/spacemen are standing on the cratered surface of some planet or moon
the landscape is a rather uniform one of small craters
the only thing on the surface are these dark boomerang shapes about a foot long
one astronaut says to the other - "So this is where all the missing socks go!"
-----
#9
Senior Member
Join Date: Aug 2013
Posts: 2,336
Mentioned: 35 Post(s)
Tagged: 0 Thread(s)
Quoted: 767 Post(s)
Liked 1,897 Times
in
889 Posts
In the bucket right beside the oil hole clip bucket, of course.
Sorry, I couldn't resist.
Here's another question: For all of the missing pedal dust caps out there, has anyone ever found one out on the road?
Sorry, I couldn't resist.
Here's another question: For all of the missing pedal dust caps out there, has anyone ever found one out on the road?
Likes For BFisher:
#10
Senior Member
Join Date: Oct 2010
Posts: 8,755
Mentioned: 69 Post(s)
Tagged: 0 Thread(s)
Quoted: 3190 Post(s)
Liked 2,460 Times
in
1,489 Posts
I think that young girls pick them up. Everyone one of them, so I've heard.
Last edited by seypat; 01-09-23 at 06:14 PM.
#11
Senior Member
Thread Starter
Join Date: Jul 2022
Location: Pac NW
Posts: 1,910
Bikes: several Eddy Merz (ride like Eddy, braze like Jim!)
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 1040 Post(s)
Liked 1,698 Times
in
624 Posts
BFisher said: Here's another question: For all of the missing pedal dust caps out there, has anyone ever found one out on the road?
No, and I walk my dog everywhere, usually along bike paths. Never seen one in the wild.
No, and I walk my dog everywhere, usually along bike paths. Never seen one in the wild.
__________________
"Leave the gun. Take the Colnagos."
"Leave the gun. Take the Colnagos."
#12
Newbie
#13
SE Wis
Join Date: Apr 2005
Location: Milwaukee, WI
Posts: 10,516
Bikes: '68 Raleigh Sprite, '02 Raleigh C500, '84 Raleigh Gran Prix, '91 Trek 400, 2013 Novara Randonee, 1990 Trek 970
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 2731 Post(s)
Liked 3,361 Times
in
2,034 Posts
#14
Edumacator
Join Date: Jan 2018
Location: Goose Creek, SC
Posts: 7,429
Bikes: '87 Crestdale, '87 Basso Gap, '92 Rossin Performance EL-OS, 1990 VanTuyl, 1980s Losa, 1985 Trek 670, 1982 AD SLE, 1987 PX10, etc...
Mentioned: 56 Post(s)
Tagged: 0 Thread(s)
Quoted: 2385 Post(s)
Liked 2,930 Times
in
1,861 Posts
Island of misfit caps...
__________________
1987 Crest Cannondale, 1987 Basso Gap, 1992 Rossin Performance EL, 1990ish Van Tuyl, 1985 Trek 670, 1982 AD SLE, 2003 Pinarello Surprise, 1990ish MBK Atlantique, 1987 Peugeot Competition, 1987 Nishiki Tri-A, 1981 Faggin, 1996 Cannondale M500, 1984 Mercian, 1982 AD SuperLeicht, 1985 Massi (model unknown), 1988 Daccordi Griffe , 1989 Fauxsin MTB, 1981 Ciocc Mockba, 1992 Bianchi Giro, 1977 Colnago Super
1987 Crest Cannondale, 1987 Basso Gap, 1992 Rossin Performance EL, 1990ish Van Tuyl, 1985 Trek 670, 1982 AD SLE, 2003 Pinarello Surprise, 1990ish MBK Atlantique, 1987 Peugeot Competition, 1987 Nishiki Tri-A, 1981 Faggin, 1996 Cannondale M500, 1984 Mercian, 1982 AD SuperLeicht, 1985 Massi (model unknown), 1988 Daccordi Griffe , 1989 Fauxsin MTB, 1981 Ciocc Mockba, 1992 Bianchi Giro, 1977 Colnago Super
#15
Senior Member
Where do al the pedal caps go?
If they're good, they go to Pedal Cap Heaven.
If they're bad, they get recycled into a part destined for a really cheap department store bike.
If they're good, they go to Pedal Cap Heaven.
If they're bad, they get recycled into a part destined for a really cheap department store bike.
#16
All Campy All The Time
Join Date: Nov 2013
Location: Richmond, Virginia
Posts: 1,425
Bikes: Listed in my signature.
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 175 Post(s)
Liked 114 Times
in
63 Posts
Some of them go on Ebay at real high prices.
__________________
My C&V Bikes:
1972 Bottecchia Professional, 1972 Legnano Olympiade Record,
1982 Colnago Super, 1987 Bottecchia Team C-Record,
1988 Pinarello Montello, 1990 Masi Nuova Strada Super Record,
1995 Bianchi Campione d'Italia, 1995 DeBernardi Thron
My C&V Bikes:
1972 Bottecchia Professional, 1972 Legnano Olympiade Record,
1982 Colnago Super, 1987 Bottecchia Team C-Record,
1988 Pinarello Montello, 1990 Masi Nuova Strada Super Record,
1995 Bianchi Campione d'Italia, 1995 DeBernardi Thron
#17
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,830
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 128 Post(s)
Tagged: 0 Thread(s)
Quoted: 4743 Post(s)
Liked 3,860 Times
in
2,509 Posts
#18
Not lost wanderer.
Join Date: Jan 2013
Location: Lititz, Pa
Posts: 3,359
Bikes: In USA; 73 Raleigh Super Course dingle speed, 72 Raleigh Gran Sport SS, 72 Geoffry Butler, 81 Centurion Pro-Tour, 74 Gugie Grandier Sportier
Mentioned: 72 Post(s)
Tagged: 0 Thread(s)
Quoted: 885 Post(s)
Liked 979 Times
in
514 Posts
They are on Tesla's time shelf with hats and old socks just below Tupperware lids.
__________________
Cambodia bikes, Bridgestone SRAM 2 speed, 2012 Fuji Stratos...
Cambodia bikes, Bridgestone SRAM 2 speed, 2012 Fuji Stratos...