Knobby Tire Wearing Out Faster On Pavement
#1
Senior Member
Thread Starter
Join Date: May 2010
Location: Bastrop Texas
Posts: 4,461
Bikes: Univega, Peu P6, Peu PR-10, Ted Williams, Peu UO-8, Peu UO-18 Mixte, Peu Dolomites
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 952 Post(s)
Liked 1,619 Times
in
1,039 Posts
Knobby Tire Wearing Out Faster On Pavement
Strange as it may seem it appears that my touring tires with the pronounced knobs is wearing out faster than when used on regular pavement. I have used Kenda and Continental touring tires on my local bike routes. Half of each route is well paved asphalt with the other half mostly torn up pavement. The torn up pavement is light gravel unless I have to go off road to avoid large pot holes. During inclement weather I stay mostly on the well paved roads. Oddly I have noticed more wear to the knobby areas of my tiers when used on the well paved roads then on the gravel. Any comments?
__________________
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
#2
(rhymes with spook)
Join Date: Aug 2009
Location: Winslow, AR
Posts: 2,788
Bikes: '83 univega gran turismo x2, '85 schwinn super le tour,'89 miyata triple cross, '91 GT tequesta, '90 yokota grizzly peak, '94 GT backwoods, '95'ish scott tampico, '98 bonty privateer, '93 mongoose crossway 625, '98 parkpre ariel, 2k'ish giant fcr3
Mentioned: 26 Post(s)
Tagged: 0 Thread(s)
Quoted: 919 Post(s)
Liked 745 Times
in
546 Posts
you have to think in terms of friction and also the tire composition. there's a lot more friction (heat + surface contact) from pavement than on irregular surfaces. on top of that, the knobs are going to be made of a softer composite that's better for surface conformity/grip on irregularities while the smoother areas of tread are harder. which is better for longevity and maximum surface contact on pavement
Likes For thook:
#3
working on my sandal tan
Join Date: Aug 2011
Location: CID
Posts: 22,626
Bikes: 1991 Bianchi Eros, 1964 Armstrong, 1988 Diamondback Ascent, 1988 Bianchi Premio, 1987 Bianchi Sport SX, 1980s Raleigh mixte (hers), All-City Space Horse (hers)
Mentioned: 98 Post(s)
Tagged: 0 Thread(s)
Quoted: 3870 Post(s)
Liked 2,563 Times
in
1,577 Posts
Strange as it may seem it appears that my touring tires with the pronounced knobs is wearing out faster than when used on regular pavement. I have used Kenda and Continental touring tires on my local bike routes. Half of each route is well paved asphalt with the other half mostly torn up pavement. The torn up pavement is light gravel unless I have to go off road to avoid large pot holes. During inclement weather I stay mostly on the well paved roads. Oddly I have noticed more wear to the knobby areas of my tiers when used on the well paved roads then on the gravel. Any comments?
__________________
RUSA #7498
Originally Posted by noglider
People in this forum are not typical.
Last edited by ThermionicScott; 08-13-21 at 04:33 PM.
Likes For ThermionicScott:
#4
Life Feeds On Life
Join Date: Jan 2018
Location: Hondo,Texas
Posts: 2,143
Bikes: Too many Motobecanes
Mentioned: 11 Post(s)
Tagged: 0 Thread(s)
Quoted: 4405 Post(s)
Liked 4,520 Times
in
3,022 Posts
Aggressive truck tires wear out faster than slicker highway style tires on pavement. I’m guessing that can apply to bicycle tires as well.
Likes For Hondo Gravel:
#5
Senior Member
Join Date: Jul 2014
Location: Central Indiana
Posts: 2,159
Mentioned: 27 Post(s)
Tagged: 0 Thread(s)
Quoted: 912 Post(s)
Liked 514 Times
in
343 Posts
Don't forget to factor in speed and braking differences while computing tread wear between gravel/broken road versus smooth (abrasive) roads.
#6
Keepin it Wheel
Join Date: Aug 2011
Location: San Diego
Posts: 10,243
Bikes: Surly CrossCheck, Krampus
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 26 Post(s)
Liked 3,413 Times
in
2,522 Posts
I ride my MTB to my local trails and have to cover sometimes a mile or two paved to get to the dirt. I've often wondered, is it better for me (for my tires) to ride on asphalt or concrete (i.e. road or sidewalk)? (If sidewalk, I would scrupulously yield to the very few pedestrians I would encounter)
Also, I recently noticed that the Schwalbe Hurricanes on my commuter, the right-side knobs are seriously ground down, but the left-side knobs are pristine. Evidence that my right-turns are always sharper than my left turns. 'murica!
Also, I recently noticed that the Schwalbe Hurricanes on my commuter, the right-side knobs are seriously ground down, but the left-side knobs are pristine. Evidence that my right-turns are always sharper than my left turns. 'murica!
#7
Forum Moderator
Join Date: Jul 2007
Location: Kalamazoo MI
Posts: 20,625
Bikes: Fuji SL2.1 Carbon Di2 Cannondale Synapse Alloy 4 Trek Checkpoint ALR-5 Viscount Aerospace Pro Colnago Classic Rabobank Schwinn Waterford PMount Raleigh C50 Cromoly Hybrid Legnano Tipo Roma Pista
Mentioned: 58 Post(s)
Tagged: 0 Thread(s)
Quoted: 3084 Post(s)
Liked 6,553 Times
in
3,761 Posts
Thread moved from Foo to General Cycling Discussion.
__________________
#8
cowboy, steel horse, etc
Join Date: Sep 2008
Location: The hot spot.
Posts: 44,783
Bikes: everywhere
Mentioned: 71 Post(s)
Tagged: 1 Thread(s)
Quoted: 12736 Post(s)
Liked 7,643 Times
in
4,053 Posts
Yeah pavement wrecks knobbies. Knobbies wear out faster on the rocky trails here in PHX than the softer trails around PDX also.
Likes For LesterOfPuppets:
#9
Senior Member
Join Date: Jul 2017
Location: Walnut Creek, CA
Posts: 756
Bikes: 1969 Peugeot PX10, 1992 Della Santa, Linus Roadster 8, Biria 700C ST-8
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 791 Post(s)
Liked 503 Times
in
320 Posts
Makes sense to me. Knobbies are noisier on pavement, I suppose that noise comes from higher wear. Wear else?
#10
Senior Member
There are some here on the forum who carry a second set of wheels and tires with them.... They strap their knobby tires onto their backpack and then once they arrive at the trail, change out the slick tires and wheels in favor of the knobbies.
#11
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 14,938
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6165 Post(s)
Liked 4,782 Times
in
3,300 Posts
This almost deserves a "duh"!
Yes, you people running knobbies on pavement can be heard a long way away. Of course they are creating morefriction bumps to increase your rolling resistance and sapping you of energy you could better use to ride further or stronger. Essentially you are taking your own section of chip-seal road with you for the ride.
Personally I wouldn't use knobbies in anything but dirt, sand or mud. For gravel or broken up pavement I can see where some heavier tread pattern might be desired, but not to the extent of knobbies.
Yes, you people running knobbies on pavement can be heard a long way away. Of course they are creating more
Personally I wouldn't use knobbies in anything but dirt, sand or mud. For gravel or broken up pavement I can see where some heavier tread pattern might be desired, but not to the extent of knobbies.
Last edited by Iride01; 08-17-21 at 04:47 PM. Reason: Friction might be technically incorrect. So I reworded it but might start another controversy in the process <grin>
Likes For Iride01:
#12
Senior Member
Join Date: Jul 2013
Location: Nor-Cal
Posts: 3,767
Bikes: lots
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Quoted: 1958 Post(s)
Liked 2,932 Times
in
1,489 Posts
^This^ How could it be a surprise that soft, knobby mtb tires don't last as long on pavement? It seems so obvious.
Likes For cxwrench:
#13
Sunshine
Join Date: Aug 2014
Location: Des Moines, IA
Posts: 16,604
Bikes: '18 class built steel roadbike, '19 Fairlight Secan, '88 Schwinn Premis , Black Mountain Cycles Monstercross V4, '89 Novara Trionfo
Mentioned: 123 Post(s)
Tagged: 0 Thread(s)
Quoted: 10945 Post(s)
Liked 7,473 Times
in
4,181 Posts
I get soaked faster when I spray myself with a hose compared to when I run thru a sprinkler.
Likes For msu2001la:
#15
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,545
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Mentioned: 112 Post(s)
Tagged: 0 Thread(s)
Quoted: 5222 Post(s)
Liked 3,575 Times
in
2,339 Posts
I like gravel but I don't like knobby tires
Last edited by rumrunn6; 08-18-21 at 08:05 AM.
Likes For rumrunn6:
#16
Grupetto Bob
Join Date: Sep 2020
Location: Seattle-ish
Posts: 6,170
Bikes: Bikey McBike Face
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 2558 Post(s)
Liked 5,586 Times
in
2,898 Posts
Strange as it may seem it appears that my touring tires with the pronounced knobs is wearing out faster than when used on regular pavement. I have used Kenda and Continental touring tires on my local bike routes. Half of each route is well paved asphalt with the other half mostly torn up pavement. The torn up pavement is light gravel unless I have to go off road to avoid large pot holes. During inclement weather I stay mostly on the well paved roads. Oddly I have noticed more wear to the knobby areas of my tiers when used on the well paved roads then on the gravel. Any comments?
__________________
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
#17
Senior Member
the knobbier it is, the faster it will wear out on pavement. Generally speaking, knobbies will wear down faster than slicks or semi-slicks regardless of terrain.
#18
Keepin it Wheel
Join Date: Aug 2011
Location: San Diego
Posts: 10,243
Bikes: Surly CrossCheck, Krampus
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 26 Post(s)
Liked 3,413 Times
in
2,522 Posts
Any thoughts on asphalt vs concrete, which will grind down knobbies quicker?
#19
Advocatus Diaboli
Join Date: Feb 2015
Location: Wherever I am
Posts: 8,631
Bikes: Merlin Cyrene, Nashbar steel CX
Mentioned: 14 Post(s)
Tagged: 1 Thread(s)
Quoted: 4729 Post(s)
Liked 1,531 Times
in
1,002 Posts
This almost deserves a "duh"!
Yes, you people running knobbies on pavement can be heard a long way away. Of course they are creating morefriction bumps to increase your rolling resistance and sapping you of energy you could better use to ride further or stronger. Essentially you are taking your own section of chip-seal road with you for the ride.
Personally I wouldn't use knobbies in anything but dirt, sand or mud. For gravel or broken up pavement I can see where some heavier tread pattern might be desired, but not to the extent of knobbies.
Yes, you people running knobbies on pavement can be heard a long way away. Of course they are creating more
Personally I wouldn't use knobbies in anything but dirt, sand or mud. For gravel or broken up pavement I can see where some heavier tread pattern might be desired, but not to the extent of knobbies.