Tool needed for an early Cinelli headset?
01-23-23, 05:54 PM
#1
Junior Member
Thread Starter
Tool needed for an early Cinelli headset?
I'm sure this has been discussed before but what tool and where can it be found to remove this head set...thanks
01-23-23, 06:50 PM
#2
blahblahblah chrome moly
Join Date: Apr 2009
Location: Seattle
Posts: 1,986
Mentioned: 92 Post(s)
Tagged: 0 Thread(s)
Quoted: 1172 Post(s)
Liked 2,567 Times
in
1,072 Posts
There's only one tool for this:
Kidding! Those are super rare and $$$$ when you can find one.
Much more commonly available, the VAR #13 adjustable pin spanner, usually used on BB adjustable cups, can have the pins put in facing each other like this.
There was a Park pin spanner with the hooks facing inward, I forget the part number, no longer made I think. The hooks weren't round, but I filed them to round on mine, for use on a similar Bianchi headset.
That takes a steady hand and some filing skill to do it well. Use a fine file and go slow, take it down only until the pins barely fit, leaving them as large as possible for strength — since they aren't replaceable.
I have also done it with a cheap stamped-steel BB pin spanner where I just twisted both of the arms 90° until they faced inward. Can't find it though, sorry no pictures.
I started with one like this Park SPA-6:
Made of weak and malleable steel, so twisting was easy with a vise and an adjustable wrench. Maybe do-able with just two wrenches if you don't have a vise.
Mark B
Kidding! Those are super rare and $$$$ when you can find one.
Much more commonly available, the VAR #13 adjustable pin spanner, usually used on BB adjustable cups, can have the pins put in facing each other like this.
There was a Park pin spanner with the hooks facing inward, I forget the part number, no longer made I think. The hooks weren't round, but I filed them to round on mine, for use on a similar Bianchi headset.
That takes a steady hand and some filing skill to do it well. Use a fine file and go slow, take it down only until the pins barely fit, leaving them as large as possible for strength — since they aren't replaceable.
I have also done it with a cheap stamped-steel BB pin spanner where I just twisted both of the arms 90° until they faced inward. Can't find it though, sorry no pictures.
I started with one like this Park SPA-6:
Made of weak and malleable steel, so twisting was easy with a vise and an adjustable wrench. Maybe do-able with just two wrenches if you don't have a vise.
Mark B
Likes For bulgie:
01-23-23, 09:26 PM
#3
Old fart
Join Date: Nov 2004
Location: Appleton WI
Posts: 24,784
Bikes: Several, mostly not name brands.
Mentioned: 153 Post(s)
Tagged: 0 Thread(s)
Quoted: 3587 Post(s)
Liked 3,400 Times
in
1,934 Posts
Agree. VAR-13 will work.
01-23-23, 09:41 PM
#4
Senior Member
Join Date: Feb 2013
Location: Alta California
Posts: 14,260
Mentioned: 415 Post(s)
Tagged: 1 Thread(s)
Quoted: 3810 Post(s)
Liked 3,335 Times
in
2,175 Posts
-----
Tullio tool Nr. 772 -
-----
Tullio tool Nr. 772 -
-----
