Should I drill my brake bridge?
#26
Ride, Wrench, Swap, Race
Join Date: Jan 2010
Location: Northern California
Posts: 9,193
Bikes: Cheltenham-Pedersen racer, Boulder F/S Paris-Roubaix, Varsity racer, '52 Christophe, '62 Continental, '92 Merckx, '75 Limongi, '76 Presto, '72 Gitane SC, '71 Schwinn SS, etc.
Mentioned: 132 Post(s)
Tagged: 0 Thread(s)
Quoted: 1565 Post(s)
Liked 1,295 Times
in
865 Posts
At least with the old Record calipers, there were three stud lengths and the mid-sized one was used both for the front,recessed, and for the rear, nutted.
So since that length was used in two applications, it should be the most common to find, and would work on either the front or rear of this bike.
I don't think that this one was Lippy-built, as those had a distinctive curvature to the fork legs that I don't think I am seeing here.
So since that length was used in two applications, it should be the most common to find, and would work on either the front or rear of this bike.
I don't think that this one was Lippy-built, as those had a distinctive curvature to the fork legs that I don't think I am seeing here.
#27
Friendship is Magic
Join Date: Nov 2010
Location: Sacramento, CA
Posts: 22,984
Bikes: old ones
Mentioned: 304 Post(s)
Tagged: 0 Thread(s)
Quoted: 26400 Post(s)
Liked 10,373 Times
in
7,202 Posts
....it's pretty easy to make one, by just taking the recessed mounting nut of your choice, and drilling out the threads inside it, so the brake bolt slides on through cleanly.