Go Back  Bike Forums > Bike Forums > Tandem Cycling
Reload this Page >

MTB Shoes with Deep Cleat Pocket

Search
Notices
Tandem Cycling A bicycle built for two. Want to find out more about this wonderful world of tandems? Check out this forum to talk with other tandem enthusiasts. Captains and stokers welcome!

MTB Shoes with Deep Cleat Pocket

Thread Tools
 
Search this Thread
 
Old 09-02-22, 12:08 PM
  #1  
joeruge
Full Member
Thread Starter
 
Join Date: Jan 2006
Posts: 217
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 79 Post(s)
Liked 74 Times in 41 Posts
MTB Shoes with Deep Cleat Pocket

Hey folks,
I'm one of those tandem captains, like many of you, that uses MTB type shoes. I like to have good secure foot placement when placing a foot down at stops. I have been using Fi'zi;k Terra X5 shoes for the last few years and it's time to replace. They are pretty good - good fit for me, didn't look too out of place around my roadie buddies on their singles and were reasonably priced. They had a few problems which I'd like to avoid with my next pair: The 'cleat pocket' (a term I have just learned) is not very deep. This allows the cleat to come into contact with the asphalt first. Just this last Sunday I put my foot down on a white line and the cleat slipped on the smooth paint - until the lugs started to make contact. Additionally, the portion of the sole between the front lugs and the heel is smooth hard plastic, no grip at all really. Putting that portion of your foot down on say a rail or a smooth curb while just walking around off the bike is a real problem.

Have any of you found a pair of MTB (cross country gravel?) shoes that have a decently deep cleat pocket (or conversely, tall lugs), have something 'rubbery' between the front lugs and the heel (or more lugs) and don't look too dorky? A stiff shoe is fine. I'm not too concerned about 'walkability' except when I walk I don't want the cleat to scratch the ground (or sometimes floors!). I know fit is personal but I'll mention that I have a narrow foot, if that helps with the suggestions. I wear the Terra X5's in size 44.5

Thanks for any suggestions.
joeruge is offline  
Old 09-02-22, 06:08 PM
  #2  
bboy314
Senior Member
 
bboy314's Avatar
 
Join Date: Dec 2008
Location: Pioneer Valley
Posts: 971
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 313 Post(s)
Liked 715 Times in 368 Posts
https://www.rei.com/product/141417/s...17890005612673

I’m a big fan of these Shimano shoes, comfortable to walk in and it seems like I rarely feel the cleat touch the ground.
bboy314 is offline  
Old 09-02-22, 07:07 PM
  #3  
Alcanbrad
Full Member
 
Alcanbrad's Avatar
 
Join Date: Apr 2015
Location: New Jersey
Posts: 430

Bikes: '14 CoMo Carrera, '11 CoMo Primera co-pilot, '98 Santana Visa, a Plethora of road bikes, A commuter/Gravel beast (and 1 MTB)

Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 106 Post(s)
Liked 45 Times in 38 Posts
Originally Posted by bboy314
https://www.rei.com/product/141417/s...17890005612673

I’m a big fan of these Shimano shoes, comfortable to walk in and it seems like I rarely feel the cleat touch the ground.
+1 and they offer a very wide toe box available if needed.

Last edited by Alcanbrad; 09-05-22 at 10:16 AM.
Alcanbrad is offline  
Old 09-03-22, 09:31 AM
  #4  
joeruge
Full Member
Thread Starter
 
Join Date: Jan 2006
Posts: 217
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 79 Post(s)
Liked 74 Times in 41 Posts
Thanks for the suggestion. We have an REI locally and it sounds like it would be worth while checking them out.
JR
​​
joeruge is offline  
Old 09-03-22, 10:07 AM
  #5  
79pmooney
Senior Member
 
79pmooney's Avatar
 
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,892

Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder

Mentioned: 129 Post(s)
Tagged: 0 Thread(s)
Quoted: 4792 Post(s)
Liked 3,918 Times in 2,548 Posts
Another possibility that opens up many more shoe options - have a cobbler glue on additional sole. Or buy sole material and glue in on with 3M 5200. I've done both. A cobbler has turned two road shoes with 3-bolt LOOK style cleats and smooth soles into very walkable shoes where the cleats both last far longer and do not scar good floors.

More recently I learned one leg is a half inch shorter and I've started using 1/4" shims. So I glued 1/4" sole to that MTB shoe with the 5200. (It cures to a consistency like sole rubber and is very both strong and durable. Does not shrink and can fill large voids. Gluing sole material directly over the MTB lugged pattern worked just fine and has been walked on every Saturday morning 's farmers market for years. (I used to use 5200 to glue decks of fiberglass sailboats to the hulls. Secured with bolts every 6-8 inches but you can remove the bolts and pick those boats up by the deck, If there is failure, it will be the fiberglass, not the 5200.) The stuff is expensive, gives you hours of working time, takes several days to cure, powerful solvents to clean up and the tube will cure in days once opened so nothing about it is a small deal, but that repair is permanent,

And to make shoes less slippery - low tech and cheap - Shoe Goo.
79pmooney is offline  
Old 09-04-22, 04:56 PM
  #6  
CaliTexan
Newbie
 
CaliTexan's Avatar
 
Join Date: Apr 2018
Posts: 44

Bikes: 2019 Co-Motion Carrera (S&S) / 1998 Litespeed Tuscany / 2014 Wilier Zero 7

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 7 Post(s)
Liked 14 Times in 8 Posts
I’ve ridden with Sidi MTB shoes on the tandems for several decades. They’re not cheap, but periodically you can find the model you want on-line deeply discounted. They are stable for walking, durable, many different models & widths. I always use SPD multi-release cleats. The styles change very slowly, so you can find replacement parts pretty easily. And, when you’ve worn them out, you can replace them with a very similar model. Examples here -

https://www.amazon.com/Sidi-Dominato...-46&th=1&psc=1
CaliTexan is offline  
Old 09-04-22, 07:38 PM
  #7  
quickrelease5
Newbie
 
Join Date: Jan 2017
Location: New York
Posts: 22

Bikes: 2019 Calfee tetra SRAM etap, 2009 colnago EPS, 2000 Trek 5.9 Domaine, 1978 Holdsworth professional

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Likes: 0
Liked 4 Times in 2 Posts
these SIDI shoes fit the bill and go on sale sometimes. they are the best. Wish they made them in women's sizes too.

https://www.competitivecyclist.com/s...ling-shoe-mens
quickrelease5 is offline  
Old 09-04-22, 07:39 PM
  #8  
quickrelease5
Newbie
 
Join Date: Jan 2017
Location: New York
Posts: 22

Bikes: 2019 Calfee tetra SRAM etap, 2009 colnago EPS, 2000 Trek 5.9 Domaine, 1978 Holdsworth professional

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 12 Post(s)
Likes: 0
Liked 4 Times in 2 Posts
SD 15 cycling shoe - not sure if the link was correct
quickrelease5 is offline  
Old 09-04-22, 08:22 PM
  #9  
joeruge
Full Member
Thread Starter
 
Join Date: Jan 2006
Posts: 217
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 79 Post(s)
Liked 74 Times in 41 Posts
Hey, you folks are great. Thanks for all the suggestions. I'll look around for Sidis, and the cobbler idea is brilliant!
joeruge is offline  
Old 09-06-22, 08:58 AM
  #10  
Freerojo
Junior Member
 
Join Date: May 2008
Posts: 182

Bikes: 1997 Specialized Hardrock GX, 2008 Specialized Roubaix Triple 105, 1996 Cannondale RT2000 tandem

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 48 Post(s)
Liked 19 Times in 14 Posts
https://www.specialized.com/us/en/ri...=268774-172838

I have these. Really lightweight and comfortable.
Freerojo is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.