Cycleops Bike Trainer with a Single Speed Bolt on Axle
#1
Newbie
Thread Starter
Join Date: May 2013
Location: New York City
Posts: 2
Bikes: Unknown branded mountain bike
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Cycleops Bike Trainer with a Single Speed Bolt on Axle
Hi all, I have been trying to set up my single speed bike with no quick release axle onto a cycleops trainer but the bike keeps falling off. The nut on my bike does not fit into the moveable tube provided with the trainer.
In the youtube video "Bolt-On Axle Assembly with CycleOps Indoor Bike Trainers"
from bikemanforu he shows an adapter for single speed bikes but I cannot find a similar setup anywhere else. Would anyone be able to point me in the right direction?
*cannot post links or videos because I am under 10 posts*
In the youtube video "Bolt-On Axle Assembly with CycleOps Indoor Bike Trainers"
from bikemanforu he shows an adapter for single speed bikes but I cannot find a similar setup anywhere else. Would anyone be able to point me in the right direction?
*cannot post links or videos because I am under 10 posts*
#2
SE Wis
Join Date: Apr 2005
Location: Milwaukee, WI
Posts: 10,501
Bikes: '68 Raleigh Sprite, '02 Raleigh C500, '84 Raleigh Gran Prix, '91 Trek 400, 2013 Novara Randonee, 1990 Trek 970
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 2742 Post(s)
Liked 3,389 Times
in
2,052 Posts
#3
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,056
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4195 Post(s)
Liked 3,837 Times
in
2,295 Posts
Sometimes the axle nut won't fully seat in the trainer's axle cups due to the shapes and dimensions not quite matching. Either the axle extends too far out of that nut and it's end bottoms out on the cup's base or the cup is too wide to grip the nut before the cup's lip contacts the drop out. Sometimes adding a second nut outboard to the OEM one will allow better cup seating. If this is happening the solution is very low cost and available from LBS or another axle nutted bike. Andy
__________________
AndrewRStewart
AndrewRStewart