Odd question about my Univega CB6.3 Frame
#1
Senior Member
Thread Starter
Join Date: Oct 2017
Posts: 61
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 13 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Odd question about my Univega CB6.3 Frame
I just picked this frame up and where the rear wheel mounts up it has a removable bracket on the cassette side. The frame didn't come with the bracket and Ive never seen this setup on a frame before so I don't even know what the name of the pare is to look it up. The frame is a 94 Univega CB6.3 Carbon Fiber with Kevlar Reinforced Stays if this information helps.
#2
Bad example
Join Date: Nov 2015
Location: Seattle and Reims
Posts: 3,061
Bikes: Peugeot: AO-8 1973, PA-10 1971, PR-10 1973, Sante 1988; Masi Gran Criterium 1975, Stevenson Tourer 1980, Stevenson Criterium 1981, Schwinn Paramount 1972, Rodriguez 2006, Gitane Federal ~1975, Holdsworth Pro, Follis 172 ~1973, Bianchi '62
Mentioned: 36 Post(s)
Tagged: 0 Thread(s)
Quoted: 823 Post(s)
Liked 205 Times
in
93 Posts
Sounds like a derailleur hanger.
#3
Senior Member
Thread Starter
Join Date: Oct 2017
Posts: 61
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 13 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I had looked at those. I need one where if Im looking at the hub from the right side of the wheel, it takes two mounting bolts on the right of the bracket and the hub hanger on the left, not in the middle of the two holes.
Thread
Thread Starter
Forum
Replies
Last Post
Syncmaster
Bicycle Mechanics
6
05-20-15 12:06 PM
wigglrpop
Bicycle Mechanics
5
05-22-14 07:37 PM
Campag4life
Road Cycling
16
04-29-10 08:21 AM