Riding out of the saddle difficulty
#76
Senior Member
Join Date: Oct 2015
Posts: 15,160
Bikes: 2015 Workswell 066, 2017 Workswell 093, 2014 Dawes Sheila, 1983 Cannondale 500, 1984 Raleigh Olympian, 2007 Cannondale Rize 4, 2017 Fuji Sportif 1 LE
Mentioned: 143 Post(s)
Tagged: 0 Thread(s)
Quoted: 7454 Post(s)
Liked 3,141 Times
in
1,678 Posts
I don't think cyclists are "pulling up on the bars." Cyclists (as in the track cycling example immediately above) are pressing so hard with their legs against gearing so high that they are driving their bodies upward .... they are using leverage off the bars to push or hold their bodies down so the force reacts through the pedals. They are not lifting the bars, they are fighting the resistance with their whole bodies ... effectively driving their bodies down from the bars.
If they were actually lifting the bars they'd wheelie.
If they were actually lifting the bars they'd wheelie.
Likes For Maelochs:
#77
Newbie racer
Join Date: Feb 2018
Posts: 3,398
Bikes: Propel, red is faster
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
Quoted: 1572 Post(s)
Liked 1,558 Times
in
968 Posts
Want to ask about this technique as I’m finding it surprisingly exhausting and incapable of doing it for very long at all. I consider myself at least a moderately conditioned cyclist doing centuries a few times a year and around 200,000’ annual climbing numbers. At times that I try riding out of the saddle, it’s not long at all before I sit back down. I have specific points along a favorite route where I intentionally work on it but I’ll be damned if I can see any improvement.
Either way I find which bike I am on makes or breaks it being enjoyable or a chore. TT bike, absolute chore. Aero road bike with low stack and long reach, not as bad as the TT but not ideal. Cyclocross bike with more stack less reach, very fun and ideal feel.
#78
Cheerfully low end
Join Date: Jun 2020
Posts: 1,887
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 618 Post(s)
Liked 985 Times
in
627 Posts
I don't think cyclists are "pulling up on the bars." Cyclists (as in the track cycling example immediately above) are pressing so hard with their legs against gearing so high that they are driving their bodies upward .... they are using leverage off the bars to push or hold their bodies down so the force reacts through the pedals. They are not lifting the bars, they are fighting the resistance with their whole bodies ... effectively driving their bodies down from the bars.
If they were actually lifting the bars they'd wheelie.
If they were actually lifting the bars they'd wheelie.
Pulling up means exerting force up on the underside of the bar so that the reaction force of the bar pushes your hands down and keeps your upper body attached to the bike. When pedaling forces are larger than gravitational constraints, this is required.
At lesser pedaling force, there will be a net force of the body COG trying to fall and rotate down around the seat contact point that requires the hands to push down and bear weight and the reaction force from the top of the bars pushes up and keeps us in place.
Lifting the bars would require a net torque rotating you and the front of the bike around the rear wheel contact point: “a wheelie”. This becomes a problem on very steep inclines.
Otto
#79
climber has-been
Join Date: Dec 2004
Location: Palo Alto, CA
Posts: 6,322
Bikes: Scott Addict R1, Felt Z1
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
Quoted: 2736 Post(s)
Liked 2,758 Times
in
1,394 Posts
My front wheel starts lifting on each downwards pedal stroke around 13%. I can keep the front wheel down for a while by lowering my chest to the bars, but that's good only up to about 15%. At no time am I lifting the bars, but I do pull back on them to keep me from sliding off the back of the saddle. Above 15%, I'm standing any way. Then the problem becomes rear wheel traction.
__________________
Ride, Rest, Repeat
Ride, Rest, Repeat

#80
Le Crocodile
Join Date: Oct 2005
Location: Santa Barbara Calif.
Posts: 1,823
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 345 Post(s)
Liked 655 Times
in
284 Posts

It's also a rider weight (in a relative sense), if you are overweight then it's way harder to sustain. I had a pretty major weight fluctuation, and then it became very obvious. I treat OOS like riding in the drops. Every ride I incorporate both.
#81
Cheerfully low end
Join Date: Jun 2020
Posts: 1,887
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 618 Post(s)
Liked 985 Times
in
627 Posts
You don't have to be pulling up (lifting) on the bars to do a "wheelie" on a steep climb. Simply pedaling can do the trick.
My front wheel starts lifting on each downwards pedal stroke around 13%. I can keep the front wheel down for a while by lowering my chest to the bars, but that's good only up to about 15%. At no time am I lifting the bars, but I do pull back on them to keep me from sliding off the back of the saddle. Above 15%, I'm standing any way. Then the problem becomes rear wheel traction.
My front wheel starts lifting on each downwards pedal stroke around 13%. I can keep the front wheel down for a while by lowering my chest to the bars, but that's good only up to about 15%. At no time am I lifting the bars, but I do pull back on them to keep me from sliding off the back of the saddle. Above 15%, I'm standing any way. Then the problem becomes rear wheel traction.
Otto
#82
Le Crocodile
Join Date: Oct 2005
Location: Santa Barbara Calif.
Posts: 1,823
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 345 Post(s)
Liked 655 Times
in
284 Posts

This is OOS climbing geometry template. This is Marco Pantani's bike. He would ride out of the saddle for an hour at a time. He would climb in the drops, and you can see where the drops coincide with front axle. Also note the position of the saddle relative to the rear wheel. He was a diminutive man, so his stack height is "high" due to the fact that he is running 700c wheels. Look at the saddle to bar drop.
Likes For Erzulis Boat:
#83
Senior Member
I'm pretty sure any bike Pantani (or Contador, or any of the other OOS pedal dancers) hopped on magically became "climbing bikes".
Likes For wheelreason:
#84
Cheerfully low end
Join Date: Jun 2020
Posts: 1,887
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 618 Post(s)
Liked 985 Times
in
627 Posts
Otto
#85
Senior Member
Join Date: Feb 2008
Location: Mississauga/Toronto, Ontario canada
Posts: 8,636
Bikes: I have 3 singlespeed/fixed gear bikes
Mentioned: 29 Post(s)
Tagged: 0 Thread(s)
Quoted: 4114 Post(s)
Liked 2,403 Times
in
1,247 Posts
It seems that only cyclist who are 50 - 100 pounds overweight and lack fitness and coordination, that find riding out of a saddle such a big issue. Any fit and well coordinated human being who isn't overweight shouldn't have a problem riding standing up on the pedals.
#86
Klaatu..Verata..Necktie?
Join Date: May 2007
Location: SF Bay Area
Posts: 16,189
Bikes: Litespeed Ultimate, Ultegra; Canyon Endurace, 105; Battaglin MAX, Chorus; Bianchi 928 Veloce; Ritchey Road Logic, Dura Ace; Cannondale R500 RX100; Schwinn Circuit, Sante; Lotus Supreme, Dura Ace
Mentioned: 40 Post(s)
Tagged: 0 Thread(s)
Quoted: 9287 Post(s)
Liked 10,433 Times
in
5,312 Posts

__________________
"Don't take life so serious-it ain't nohow permanent."
"Everybody's gotta be somewhere." - Eccles
"Don't take life so serious-it ain't nohow permanent."
"Everybody's gotta be somewhere." - Eccles
Likes For genejockey: