Carbon Wrapped Stem, Peeling
#1
Junior Member
Thread Starter
Carbon Wrapped Stem, Peeling
Some of the carbon is peeling on my "carbon wrapped" stem. To me it looks like an aesthetic issue only and not a structural/safety issue.
Looking closely at the aluminum I can't see anything more than some chipped paint, it appears to be structurally sound. Additionally, the carbon that's peeling is very very thin and its peeling straight back on a horizontal line making me think it was just a single piece of carbon laid on a normally spec'd aluminum stem....for aesthetic and not structural reasons.
Anyone familiar with carbon-wrapped stems able to weigh-in? aesthetic or structural?
Looking closely at the aluminum I can't see anything more than some chipped paint, it appears to be structurally sound. Additionally, the carbon that's peeling is very very thin and its peeling straight back on a horizontal line making me think it was just a single piece of carbon laid on a normally spec'd aluminum stem....for aesthetic and not structural reasons.
Anyone familiar with carbon-wrapped stems able to weigh-in? aesthetic or structural?
#2
On Your Left
Join Date: Nov 2011
Location: Long Island, New York, USA
Posts: 8,373
Bikes: Trek Emonda SLR, Sram eTap, Zipp 303
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
Quoted: 3004 Post(s)
Liked 2,433 Times
in
1,187 Posts
#3
Sunshine
Join Date: Aug 2014
Location: Des Moines, IA
Posts: 16,608
Bikes: '18 class built steel roadbike, '19 Fairlight Secan, '88 Schwinn Premis , Black Mountain Cycles Monstercross V4, '89 Novara Trionfo
Mentioned: 123 Post(s)
Tagged: 0 Thread(s)
Quoted: 10954 Post(s)
Liked 7,482 Times
in
4,184 Posts
A lot of carbon stems are 'carbon wrapped alloy'. If it's peeling, just get another stem.
A Kalloy Uno 7 lightweight can be had on ebay for $25-30 and is lighter than most stems 2-4x the cost. 20 seconds of rubbing with paint thinner removes the logos and its then simple matte black.
A Kalloy Uno 7 lightweight can be had on ebay for $25-30 and is lighter than most stems 2-4x the cost. 20 seconds of rubbing with paint thinner removes the logos and its then simple matte black.