Go Back  Bike Forums > Bike Forums > Electric Bikes
Reload this Page >

Is a 60v 20ah Ebike battery supposed to go this far?

Notices
Electric Bikes Here's a place to discuss ebikes, from home grown to high-tech.

Is a 60v 20ah Ebike battery supposed to go this far?

Old 08-08-21, 09:59 AM
  #1  
Mr.Dangerous
Junior Member
Thread Starter
 
Join Date: Feb 2021
Posts: 20
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Liked 2 Times in 2 Posts
Exclamation Is a 60v 20ah Ebike battery supposed to go this far?

Hey, I have built an ebike with a 60v compatible controller and a 60v compatible twist throttle which displays accurate live voltage. The battery is a 60v 20ah battery.

When fully charged the throttle displays 67 volts and It of course decreases as I keep going. I ride the bike for around 24 miles and then the display eventually goes down to exactly 50 volts and then in goes to a 49/48 shortly after and the motor shuts off and the voltages drop to 0 and the bike automatically shuts down. Is that normal? Is it supposed to die at 49 volts and require a recharge again? its been happening every time.

I am not sure if im getting the full experience im supposed to get with a 60v 20ah battery. Thanks for looking into this!
Mr.Dangerous is offline  
Old 08-08-21, 10:26 AM
  #2  
xroadcharlie
Senior Member
 
Join Date: Apr 2019
Location: Windsor Ontario, Canada
Posts: 531

Bikes: 2018 Giant Sedona

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 179 Post(s)
Liked 116 Times in 95 Posts
I get about 72 miles based on 1200w (60V x 20A) /200w motor load for 6 hours @ 12 mph.

Most standard E bikes w/500w battery are said to go about 40 - 50 miles. They are likely much more efficient.

Perhaps your controller is not optimized for that set up. And yes, At a predetermined voltage the motor should shut down to protect it from burning out.

Last edited by xroadcharlie; 08-08-21 at 11:40 AM.
xroadcharlie is offline  
Likes For xroadcharlie:
Old 08-08-21, 10:48 AM
  #3  
gregf83 
Senior Member
 
Join Date: Jun 2008
Location: Vancouver, BC
Posts: 9,201
Mentioned: 11 Post(s)
Tagged: 0 Thread(s)
Quoted: 1186 Post(s)
Liked 289 Times in 177 Posts
Originally Posted by Mr.Dangerous
Hey, I have built an ebike with a 60v compatible controller and a 60v compatible twist throttle which displays accurate live voltage. The battery is a 60v 20ah battery.

When fully charged the throttle displays 67 volts and It of course decreases as I keep going. I ride the bike for around 24 miles and then the display eventually goes down to exactly 50 volts and then in goes to a 49/48 shortly after and the motor shuts off and the voltages drop to 0 and the bike automatically shuts down. Is that normal? Is it supposed to die at 49 volts and require a recharge again? its been happening every time.

I am not sure if im getting the full experience im supposed to get with a 60v 20ah battery. Thanks for looking into this!
Depends entirely on how fast you're riding those 24 miles. Once the battery voltage gets close to 3V/cell the internal resistance goes up and the voltage will drop quickly if you continue to draw the same power. Voltage under load is not a very good indicator of the remaining capacity in the battery. If that's all you've got you'll need to experiment a little to determine when to slow down or recharge.
gregf83 is offline  
Likes For gregf83:
Old 08-08-21, 01:06 PM
  #4  
2old
Senior Member
 
Join Date: Jul 2014
Location: socal
Posts: 4,249
Mentioned: 9 Post(s)
Tagged: 0 Thread(s)
Quoted: 877 Post(s)
Liked 810 Times in 612 Posts
What is the number of cells in series for the battery? If it's Li ion (except LiFeSO4, AIR), 14s is 58.8V (4.2 X 14). The LVC (low voltage cut-off) possibly shut the battery down in order to protect it. Beware, running a battery too close to "exhausted" isn't good for the battery and could be dangerous. At 18 or so mph (no wind, flat terrain, normal load, throttle only), you should get 40 - 45 miles. Any deviation in either direction (hill, decrease; pedal, increase) will influence this number. JMO!
2old is offline  
Likes For 2old:
Old 08-09-21, 08:32 AM
  #5  
Doc_Wui
Senior Member
 
Doc_Wui's Avatar
 
Join Date: Jul 2015
Location: Chicago Suburbs
Posts: 1,402

Bikes: GT Transeo & a half dozen ebike conversions.

Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 340 Post(s)
Liked 275 Times in 192 Posts
If this is a 16S battery using 3.7V cells, it will be 67.2V at fill charge, 59.2V when half charged, and a 60V controller will shut it down around 48V, which is 3V/cell.

You're only getting 24 miles? That's a 1200WH pack, and running it down to 3V/cell leaves you with about 20% left. SO you burned about 1000WH, which is 40WH/mile. That's high. Are you going about 30 mph? Range depends on average speed.

My little cruiser bike just went 10 miles at 15 mph, and I used about 12 WH/mile. If I had 1000WH, I could go 75 miles, but it would take me 5 hours.

Last edited by Doc_Wui; 08-09-21 at 08:35 AM. Reason: I could got 75 miles, but it woukd take me 5 hours.
Doc_Wui is offline  
Likes For Doc_Wui:
Old 08-12-21, 11:19 PM
  #6  
Mr.Dangerous
Junior Member
Thread Starter
 
Join Date: Feb 2021
Posts: 20
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Liked 2 Times in 2 Posts
Thanks everybody! I pieced it all together from all of your replies. My battery is after all an adequate battery.
Mr.Dangerous is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.