Problem with Star Trac Spinning Computer
11-08-22, 02:14 PM
#1
Newbie
Thread Starter
Join Date: Nov 2022
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Problem with Star Trac Spinning Computer
I have a Spinner NXT indoor cycle that has performed flawlessly for years. However, yesterday I noticed that the Spinning Computer was neither indicating the RPMs nor the Time. I replaced the batteries in the Spinning Computer as well as the battery in the cadence sensor. This did not resolve the problem. I then verified the 5mm distance between the sensor & the magnet. In addition, I attempted to re-sync the cadence sensor & the computer. Although I followed the instructions to the letter, I was unable to get an ID number when I waved a magnet in front of the sensor.
Any suggestions that you might offer would be most appreciated. Thank you so much.
Any suggestions that you might offer would be most appreciated. Thank you so much.
