Brazing Aluminum?
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Location: NE Ohio
Posts: 2,595
Bikes: 1992 Serotta Colorado II,Co-Motion Speedster, Giant Escape Hybrid, 1977 Schwinn Super Le Tour
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 455 Post(s)
Likes: 0
Liked 112 Times
in
85 Posts
Brazing Aluminum?
A crazy idea came to me today while moving my touring bike around in the garage. I have a rear mounted kickstand that has a rubber foot. But it wears through very quickly. So my "idea" is what about brazing a flat piece on the bottom of the kickstand to create a "foot"?
What rod and flux would I need?
Thoughts??
What rod and flux would I need?
Thoughts??
#2
Senior Member
Join Date: Jan 2013
Location: South Jersey
Posts: 2,262
Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
Quoted: 713 Post(s)
Liked 796 Times
in
473 Posts
You could try some of those Alumiweld low temp welding rods. Harbor Freight sells a version of them https://www.harborfreight.com/8-piec...ods-44810.html They are tricky to use with good results. I didn't bother trying them on my aluminum frame build. I TIG welded the bottle bosses in and used JB Weld to attach the cable guides.