How close to saltwater is too close?
#1
Junior Member
Thread Starter
How close to saltwater is too close?
I'm looking to relocate along the central Florida Atlantic coast. Is there a certain distance from the coast where damage from salt is minimal? Should it even be a factor?
#3
Banned
Warmer the water the higher the salt contents it can carry , so Florida is not where you want to be.
No place in the state is far from the sea..
No place in the state is far from the sea..
#5
Senior Member
I kept my mtb chained to a picnic table outside my RV about 300yds from Tampa Bay for two years (motorcycle and pickup as well). Covered the seat and shifters with plastic grocery sacks. Sprayed it down with the hose and WD40/chain lube every once in a while. No worse for wear. It's a bike.
Likes For Stormsedge:
#6
Senior Member
I've ridden my Fat bike on beaches and even through salt water. Just rinsed it down with a hose after, toweled it off and then lubed stuff and it was fine. Don't worry about it.
#7
- Soli Deo Gloria -
Join Date: Aug 2015
Location: Northwest Georgia
Posts: 14,779
Bikes: 2018 Rodriguez Custom Fixed Gear, 2017 Niner RLT 9 RDO, 2015 Bianchi Pista, 2002 Fuji Robaix
Mentioned: 235 Post(s)
Tagged: 0 Thread(s)
Quoted: 6844 Post(s)
Liked 736 Times
in
469 Posts
I'd be more concerned with elevation and storm surge than proximity and salt air.
Likes For TimothyH:
#9
Senior Member
Join Date: Nov 2014
Location: Eugene, Oregon, USA
Posts: 27,547
Mentioned: 217 Post(s)
Tagged: 0 Thread(s)
Quoted: 18372 Post(s)
Liked 4,507 Times
in
3,350 Posts
I'd think your impact from the sea would be minimal in a place like Orlando. It would be easy enough to see. Just visit the city, or Disney World, and see if every hinge and scrap of metal visible has deep corrosive rust on it.
Your issue, of course, is that you'll probably not just stay in Orlando. How boring would that be to be 100 miles from the sea in either direction... and never going to visit.
Your issue, of course, is that you'll probably not just stay in Orlando. How boring would that be to be 100 miles from the sea in either direction... and never going to visit.
#10
On Your Left
Join Date: Nov 2011
Location: Long Island, New York, USA
Posts: 8,373
Bikes: Trek Emonda SLR, Sram eTap, Zipp 303
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
Quoted: 3004 Post(s)
Liked 2,433 Times
in
1,187 Posts
Carbon fiber doesn't rust.
I'm 200 yards from as inlet and 1/2 mile from the open bay.
I'm 200 yards from as inlet and 1/2 mile from the open bay.
#11
Callipygian Connoisseur
Join Date: Nov 2008
Posts: 1,373
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 564 Post(s)
Liked 350 Times
in
190 Posts
I live in San Leandro and commute past the marina, along Alameda island and am literally a stones throw from the water. Heck, I suppose if I wasn't careful on the Alameda bridge I could find myself IN the water. I ride steel bikes and have done so for many, many years. I've never had a single issue with rust. Never.
-Kedosto
-Kedosto
#12
Senior Member
Join Date: Jul 2007
Location: South shore, L.I., NY
Posts: 6,877
Bikes: Flyxii FR322, Cannondale Topstone, Miyata City Liner, Specialized Chisel, Specialized Epic Evo
Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
Quoted: 3233 Post(s)
Liked 2,079 Times
in
1,177 Posts
I'm 1/3 mile from a tidal inlet, store 3 steel bikes in a basement, where it's cool. No issues in 20 years.
I'd be more concerned about the house flooding from hurricanes and would want to be well above the flood zone.
I'd be more concerned about the house flooding from hurricanes and would want to be well above the flood zone.
#13
Senior Member
You're moving to Florida and worrying about rust? As others have said, more things to worry about... like hurricanes.
Likes For WNCGoater:
#15
Senior Member
Join Date: Mar 2012
Location: Tallahassee, FL
Posts: 4,811
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 1591 Post(s)
Likes: 0
Liked 1,018 Times
in
571 Posts
Bikes that sit on the screen porch at our beach house a few hundred yards from the gulf do develop rust problems. But they're almost never ridden and never cleaned. I live 25 miles from the water and we have no problems at all. Not really an issue unless you're very close to the water and even then as long as the bike is being ridden and maintained I don't think it would be a major issue.
#16
Senior Member
It's no worse on a bike than on the millions of cars and door knobs... nothing to worry about-- just don't be so close you get sand in your chain.
#17
Senior Member
Join Date: Apr 2009
Location: New Rochelle, NY
Posts: 38,696
Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter
Mentioned: 140 Post(s)
Tagged: 1 Thread(s)
Quoted: 5774 Post(s)
Liked 2,571 Times
in
1,423 Posts
The distance you're talking about is measured in yards, not miles.
The pounding surf puts some salt into the air, where it may blow inland a ways before the salt settles out and back to earth. Humidity is also a factor as is wind direction, but a few hundred yards makes a world of difference.
What you have to worry about a bit more is riding through road puddles close to shore, since those will be salty.
This isn't anything to obsess over. I have bikes in Cozumel which is about as bad as you'd find anywhere, and there's no serious issue. Likewise, there are acti9ve cycling communities along both coasts of Florida, and if there were a material issue, there'd be all sorts of discussion about it, and products made specifically for it.
The pounding surf puts some salt into the air, where it may blow inland a ways before the salt settles out and back to earth. Humidity is also a factor as is wind direction, but a few hundred yards makes a world of difference.
What you have to worry about a bit more is riding through road puddles close to shore, since those will be salty.
This isn't anything to obsess over. I have bikes in Cozumel which is about as bad as you'd find anywhere, and there's no serious issue. Likewise, there are acti9ve cycling communities along both coasts of Florida, and if there were a material issue, there'd be all sorts of discussion about it, and products made specifically for it.
__________________
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
Likes For FBinNY:
#18
Senior Member
No worries. Just get used to hosing the bike off with fresh water and letting it dry off in the garage. I've got a steel bike (Trek 700 something or other) I've been riding up and down the beach here in Amelia and BITD Daytona since 1992 that's in great shape. Not a spot of rust anywhere. Hose it off with fresh water and fuhgetabowdit.
#19
Junior Member
Thread Starter
What's this about hurricanes? I was wondering why so many houses for sale there have new roofs on 'em.
Thanks for the tips. I don't believe we will end up too near the beach, but hosing down the bike regularly sounds easy enough. And while I am an old steel fan, the idea of using the corrosion issue for justifying a carbon bike is a good idea. Even my wife would believe that.
Thanks for the tips. I don't believe we will end up too near the beach, but hosing down the bike regularly sounds easy enough. And while I am an old steel fan, the idea of using the corrosion issue for justifying a carbon bike is a good idea. Even my wife would believe that.
#20
Cycleway town
I rode on a beach once, new mountain bike in the late '80s, on the flats. No problem with sinking in the flat damp sand, as long as i didn't stop completely. The tide was well out, but i went out far enough to get the sea water spraying everywhere - it was great fun.
The next morning i went out to do the same again, but no. My bike was solidified. The chain was just one solid piece of steel. My dad wasn't impressed. We went and got a wire brush and some WD40, and i spent a few hours saving the thing.
So......well, about 100yds out on the flats.
The next morning i went out to do the same again, but no. My bike was solidified. The chain was just one solid piece of steel. My dad wasn't impressed. We went and got a wire brush and some WD40, and i spent a few hours saving the thing.
So......well, about 100yds out on the flats.
#22
Senior Member
I'll add to all the above stuff--I used to ride one of my bikes (not regularly, but, you know) right next to the beach on awful, blowing days. Steel bike, aluminum spoke nipples, you know, all the stuff that people say will destroy it. Anyway, it was rinsed off maybe once a week, with no corrosion problems years later. One bike that gets pretty much only that treatment whenever it is ridden has a rusty chain, but that's it. It rolls/runs fine.
That said, it depends on the use of the bike. If it's hopping to the bar? Do what the locals here do: ride it, put it away wet, and buy a new one in 4-5 years when it needs to be repaired.
If it's a valuable/desirable bike, well, rinse it off when you're done.
That said, it depends on the use of the bike. If it's hopping to the bar? Do what the locals here do: ride it, put it away wet, and buy a new one in 4-5 years when it needs to be repaired.
If it's a valuable/desirable bike, well, rinse it off when you're done.
#23
Senior Member
Join Date: Jun 2011
Location: Tampa, Florida
Posts: 5,585
Bikes: 2017 Colnago C-RS, 2012 Colnago Ace, 2010 Giant Cypress hybrid
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 408 Post(s)
Liked 122 Times
in
85 Posts
I live in Tampa, about 15 miles from the bay and about 35 miles from the Gulf. I do a lot of rides along the beaches and never have hosed down my bikes after a ride. No rust on any of the metal parts on my bike. My frames are carbon so I don't even concern myself with rust on them. I also have a hybrid bike that hardly ever gets ridden and it sits under a plastic cover in our backyard shed. No big rust issues with that one either. Unless you plan on riding on beach along the water, I wouldn't worry too much about rust if you clean your bike on a regular basis.
__________________
HCFR Cycling Team
Ride Safe ... Ride Hard ... Ride Daily
2017 Colnago C-RS
2012 Colnago Ace
2010 Giant Cypress
HCFR Cycling Team
Ride Safe ... Ride Hard ... Ride Daily
2017 Colnago C-RS
2012 Colnago Ace
2010 Giant Cypress
#25
Newbie
Join Date: Oct 2017
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
I'm in Daytona Beach, half a block from the ocean and ride the beach a few times a week. Quick wipe down and lube every now and then and rust hasn't been an issue for me. The 15 miles of hard packed beach is one of the nicest rides over here.
Likes For DasBlunderbuss: