Go Back  Bike Forums > Bike Forums > Classic & Vintage
Reload this Page >

Is this Judy safe?

Notices
Classic & Vintage This forum is to discuss the many aspects of classic and vintage bicycles, including musclebikes, lightweights, middleweights, hi-wheelers, bone-shakers, safety bikes and much more.

Is this Judy safe?

Old 07-04-22, 11:16 PM
  #1  
flipchip
Chipper
Thread Starter
 
Join Date: May 2022
Posts: 20

Bikes: 1984 Miyata RidgeRunner, 1993 GT Bravado LE, 1996 Stumpjumper M2 FS

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Liked 9 Times in 6 Posts
Is this Judy safe?

posted in wrong part of the forum and not sure how to delete the thread, sorry.

Last edited by flipchip; 07-04-22 at 11:28 PM.
flipchip is offline  
Old 07-04-22, 11:31 PM
  #2  
79pmooney
A Roadie Forever
 
79pmooney's Avatar
 
Join Date: Oct 2014
Location: Portland, OR
Posts: 10,607

Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder

Mentioned: 115 Post(s)
Tagged: 0 Thread(s)
Quoted: 3494 Post(s)
Liked 2,277 Times in 1,482 Posts
I assume you are running a quill stem. If so, not a whole lot can happen even if it cracks at the rust. You will have the steerer captured by the quill wedge. The stem by the headset race. So the worst that can happen is the top of the fork goes loose. Do your best to stop before all the bearings fall out. Steering might get sloppy and tough but I'm guessing the adrenaline in your veins will carry you through.

More realistically, I'm guessing that fork will go a long, long ways just fine. That spot down low, I'd be concerned. But up there? All the top race does is keep the column in line. Not a tough job. I'd grease the heck out of the threads and spot with marine grease, to keep water and more rust away and to mark it so I remember to look again when I do HS maintenance.

Maybe others will have more concern. We'll see.

Edit: You say this is where the stem was attached. Are you saying the stem was a clamp-on for a threadless steerer? That water got in at the slot at the back and at the bolts? So this spot is above the headset and that if tie steerer broke there, the stem and HBs come off? That would make me nervous. If I loved this bike and the ride, I'd put a quill stem in it (cutting it down if need be) or take it to a framebuilder for opinion and repair.

Last edited by 79pmooney; 07-04-22 at 11:40 PM.
79pmooney is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.