ultra torque bearing orientation.
#1
Senior Member
Thread Starter
Join Date: May 2011
Location: N Central Illinois
Posts: 1,288
Bikes: 12 Bianchi Oltre VDCM,11 Bianchi Cavaria, 13 Bianchi Cavaria,12 Bianchi infinito, couple vintage Bianchi's and a 1980 alan super record
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
ultra torque bearing orientation.
Silly as it may seem, I am replacing the bearings in my ultra torque crank and upon removing the bearings I didn't check to see if the orange side of the bearing or the clear side was facing out or away from the cups. Maybe it doesn't matter? I searched forums and you tube videos and could not get a definitive answer. Can anyone help?
#2
Junior Member
Orange side being the sealed side faces outwards. Clear side being the non-sealed side faces inwards where it is protected from dirt and water by the seal in the Ultra torque cup.
#3
Senior Member
Thread Starter
Join Date: May 2011
Location: N Central Illinois
Posts: 1,288
Bikes: 12 Bianchi Oltre VDCM,11 Bianchi Cavaria, 13 Bianchi Cavaria,12 Bianchi infinito, couple vintage Bianchi's and a 1980 alan super record
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts