No Rim Tape- What to do in a pinch
#1
Senior Member
Thread Starter
Join Date: Jun 2013
Posts: 335
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 30 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
No Rim Tape- What to do in a pinch
So I royally messed up my rim tape changing a tire and am a few miles from the nearest bike shop... could I temp use electrical tape?
#5
Senior Member
Join Date: Apr 2009
Location: New Rochelle, NY
Posts: 38,725
Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter
Mentioned: 140 Post(s)
Tagged: 1 Thread(s)
Quoted: 5791 Post(s)
Liked 2,581 Times
in
1,431 Posts
Electrical tape lacks the strength of a reinforced tape and will, blow through at higher pressures or when it gets hot outside. But just about any reinforced tape will do, including cloth surgical tape, reinforced packing tape, and so on.
__________________
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
#6
Senior Member
Join Date: Jun 2015
Location: Washington State
Posts: 95
Bikes: Trek 7.4 FX (2015), Trek 1500 SLR (2005)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Do you have a sporting goods store nearby? You could try some tennis racket tape.
#8
Hogosha Sekai
Join Date: Jun 2011
Location: STS
Posts: 6,669
Bikes: Leader 725, Centurion Turbo, Scwhinn Peloton, Schwinn Premis, GT Tequesta, Bridgestone CB-2,72' Centurion Lemans, 72 Raleigh Competition
Mentioned: 19 Post(s)
Tagged: 0 Thread(s)
Quoted: 70 Post(s)
Likes: 0
Liked 21 Times
in
15 Posts
I've used a double layer in a pinch, I had meant to swap it out later but had forgotten until I had to change the tube two years later. I do agree though that I wouldn't trust it, I could see quite a few spots where the spoke nipples had almost broken through.
#9
Senior Member
Join Date: Nov 2008
Location: Bay Area, Calif.
Posts: 7,239
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 659 Post(s)
Likes: 0
Liked 7 Times
in
6 Posts
Similar experience here. Used a double layer of electrical tape. Worked ok, but after only two decades and about 100,000 miles one of the spoke holes wore through and caused a flat. Of course by then the rim's brake surface was almost worn through so it was ready for replacement. (Road bike with tires pumped up to about 110 psi.)
#11
screw campy & shimano
Join Date: May 2009
Location: North Carolina
Posts: 103
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I use excess strapping that I've cut from (too long) tie-downs, with a small piece of duct tape to hold the two ends, plus some tape sticky-rim-side down to keep the strap from sliding around during mounting.
Well, OK, this is more than an "in-a-pinch" solution. For me, it's a replacement for rim tape.
Well, OK, this is more than an "in-a-pinch" solution. For me, it's a replacement for rim tape.
Last edited by f1xedgear; 07-02-15 at 10:13 AM.
#12
Not quite there yet
Join Date: Feb 2013
Location: Monkey Bottom, NC
Posts: 999
Bikes: A bunch of old steel bikes + an ICE trike
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
A few wraps of electrical tape? Sure thing. It will get you home and many miles beyond. I used to use glass reinforced strapping tape routinely for all rims. Functionally it works great, doesn't cost much, and lasts a long time. Nowadays I have more money to spend so I have been using Newbaum's rim tape and recommend it highly when you want to replace the electrical tape
#13
Senior Member
Join Date: Feb 2014
Location: Kent Wa.
Posts: 5,332
Bikes: 2005 Gazelle Golfo, 1935 Raleigh Sport, 1970 Robin Hood sport, 1974 Schwinn Continental, 1984 Ross MTB/porteur, 2013 Flying Piegon path racer, 2014 Gazelle Toer Populair T8
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 396 Post(s)
Likes: 0
Liked 8 Times
in
7 Posts
Plastic banding material, very easy to find in the dumpster of almost any business that receives palletized freight.
#14
Senior Member
Really?
Another second world problem that would be easily solved with a simple forum/Google search.
You haven't listed your location. One could only assume that you are far enough from Alabama not to instinctively know that duct tape (AKA Alabama Chrome) would be an effective, albeit temp, cure to your dilemma.
Another second world problem that would be easily solved with a simple forum/Google search.
You haven't listed your location. One could only assume that you are far enough from Alabama not to instinctively know that duct tape (AKA Alabama Chrome) would be an effective, albeit temp, cure to your dilemma.
#15
Señior Member
Join Date: Sep 2005
Location: Michigan
Posts: 13,749
Bikes: Windsor Fens, Giant Seek 0 (2014, Alfine 8 + discs)
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 446 Post(s)
Likes: 0
Liked 8 Times
in
7 Posts
NOT electrical tape. I think first aid tape would be excellent - probably about as good as proper rim tape. Duck tape, well, maybe. In a pinch, for a while. The better grades like gaffer tape or Gorilla tape are probably good. The cheap stuff is garbage. If you live up north and have hockey tape, that'd be perfect.
I'd get them out of there ASAP though - the adhesive turns to gooey soup in a few weeks, especially if they get wet.
Electrical tape will probably work OK if your pressures are not too high (say < 50 PSI).
For that matter, at low pressures the cheap bikes use a rubber strip - if you have an old tube you could use that.
I'd get them out of there ASAP though - the adhesive turns to gooey soup in a few weeks, especially if they get wet.
Electrical tape will probably work OK if your pressures are not too high (say < 50 PSI).
For that matter, at low pressures the cheap bikes use a rubber strip - if you have an old tube you could use that.
__________________
Work: the 8 hours that separates bike rides.
Work: the 8 hours that separates bike rides.
Last edited by ItsJustMe; 07-02-15 at 01:16 PM.
#16
Senior Member
Doesn't work... Need something with non-stretchable reinforcement. Strapping tape might work.
__________________
Cat 2 Track, Cat 3 Road.
"If you’re new enough [to racing] that you would ask such question, then i would hazard a guess that if you just made up a workout that sounded hard to do, and did it, you’d probably get faster." --the tiniest sprinter
Cat 2 Track, Cat 3 Road.
"If you’re new enough [to racing] that you would ask such question, then i would hazard a guess that if you just made up a workout that sounded hard to do, and did it, you’d probably get faster." --the tiniest sprinter
#17
Senior Member
Join Date: Nov 2014
Location: Eugene, Oregon, USA
Posts: 27,547
Mentioned: 217 Post(s)
Tagged: 0 Thread(s)
Quoted: 18378 Post(s)
Liked 4,512 Times
in
3,354 Posts
What happened to the old tape?
Perhaps use it as a base layer and run electrical tape over the top.
I now have a roll of electrical tape in my seat bag. It comes in handy for many things.
Perhaps use it as a base layer and run electrical tape over the top.
I now have a roll of electrical tape in my seat bag. It comes in handy for many things.
#18
Banned
a single wall rim has different requirements, than a double wall rim, and of course the OP fails to say which kind they have.
#19
Senior Member
rim tape is used on only one of these types of rims...
__________________
Cat 2 Track, Cat 3 Road.
"If you’re new enough [to racing] that you would ask such question, then i would hazard a guess that if you just made up a workout that sounded hard to do, and did it, you’d probably get faster." --the tiniest sprinter
Cat 2 Track, Cat 3 Road.
"If you’re new enough [to racing] that you would ask such question, then i would hazard a guess that if you just made up a workout that sounded hard to do, and did it, you’d probably get faster." --the tiniest sprinter
#20
Senior Member
Join Date: Oct 2011
Location: Florida, U.S.A.
Posts: 151
Bikes: sport touring with small front back baskets. 17 mph
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
i have been through this many times heres the thrifty method that works! clean inside of rim of oil and grease let dry put 1 layer of vinyl electric tape (the cheap stuff) next a layer of medical cloth tape the plastic kind (looks like thin rim tape).
#21
Senior Member
Call your mommy to give you a ride to the bike shop............be sure to take a roll of duct tape in case a water hose blows out and you're a mile from town.
Biking------requires a bit of common sense with a touch of "McGyver" on occasion. Without some of each you'd best stick to riding the ankle express.
Biking------requires a bit of common sense with a touch of "McGyver" on occasion. Without some of each you'd best stick to riding the ankle express.
#22
Senior Member
Join Date: Aug 2007
Location: central ohio
Posts: 1,536
Bikes: 96 gary fisher 'utopia' : 99 Softride 'Norwester'(for sale), 1972 Raleigh Twenty. Surly 1x1 converted to 1x8, 96 Turner Burner
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 9 Post(s)
Likes: 0
Liked 4 Times
in
4 Posts
in a pinch I would use an old inner tube. That's one reason you don't throw them away.
#24
Banned
Join Date: Feb 2008
Location: Mississauga/Toronto, Ontario canada
Posts: 8,721
Bikes: I have 3 singlespeed/fixed gear bikes
Mentioned: 30 Post(s)
Tagged: 0 Thread(s)
Quoted: 4227 Post(s)
Liked 2,488 Times
in
1,286 Posts
I use hockey tape, it makes a perfect rim tape.
#25
Keepin it Wheel
Join Date: Aug 2011
Location: San Diego
Posts: 10,245
Bikes: Surly CrossCheck, Krampus
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 26 Post(s)
Liked 3,433 Times
in
2,540 Posts
That, and wrapping handlebars. I use a layer of old innertube underneath regular bar tape, and I don't need padded gloves.
Wait, arbitrary length? I can see small ones just by slicing the tube, or super-large ones by going all the way around, but what about in-between? Oh, I guess you can use more and more "diagonal" slices to increase the length rather arbitrarily (up to maybe even many times around the whole tube?) And what about smaller ones? I guess you can cut out a disc of any size, and then cut its insides out to make it a band. Very clever.
Wait, arbitrary length? I can see small ones just by slicing the tube, or super-large ones by going all the way around, but what about in-between? Oh, I guess you can use more and more "diagonal" slices to increase the length rather arbitrarily (up to maybe even many times around the whole tube?) And what about smaller ones? I guess you can cut out a disc of any size, and then cut its insides out to make it a band. Very clever.
Thread
Thread Starter
Forum
Replies
Last Post
CliffordK
Bicycle Mechanics
24
04-26-19 06:41 PM
Barrettscv
Bicycle Mechanics
57
11-02-13 04:02 PM